RGP15A THRU RGP15M Shanghai Lunsure Electronic Technology Co.,Ltd Tel:0086-21-37185008 Fax:0086-21-57152769 1.5 Amp Glass Passivated Junction Fast Recovery Rectifiers 50 to 1000 Volts Features • • • • High temperature metallurgically bonded construction Glass passivated cavity-free junction 1.5 amperes operation at TA= 55OC and with no thermal runaway. Typical IR less than 0.1uA Maximum Ratings • • • DO-15 Operating Temperature: -55OC to +150 OC Storage Temperature: -55OC to +150 OC Typical Thermal Resistance: 45OC/W Junction to Ambient Part Number RGP15A RGP15B RGP15D RGP15G RGP15J RGP15K RGP15M Maximum Recurrent Peak Reverse Voltage 50V 100V 200V 400V 600V 800V 1000V Maximum RMS Voltage Maximum DC Blocking Voltage 35V 70V 140V 280V 420V 560V 700V 50V 100V 200V 400V 600V 800V 1000V D A Cathode Mark B D Electrical Characteristics @ 25OC Unless Otherwise Specified Maximum Average Forward Current Peak Forward Surge Current Maximum Instantaneous Forward Voltage Maximum DC Reverse Current At Rated DC Blocking Voltage Maximum Reverse Recovery Time RGP15A-15G RGP15J RGP15K-15M Typical Junction Capacitance TA = 55OC IF(AV) 1.5 A IFSM 50A 8.3ms, half sine VF 1.3V IFM = 1.5A; TA =25OC C IR Trr CJ 5.0uA 200uA 150nS 250nS 500nS 25pF TA = 25OC TA = 150OC DIMENSIONS DIM A B C D INCHES MIN .230 .104 .026 1.000 IF=0.5A, IR=1.0A, Irr=0.25A Measured at 1.0MHz, VR=4.0V www.cnelectr.com MAX .300 .140 .034 --- MM MIN 5.80 2.60 .70 25.40 MAX 7.60 3.60 .90 --- NOTE RGP15A thru RGP15M Figure 1 Typical Forward Characteristics 20 Figure 2 Forward Derating Curve 10 3.0 6 4 2.5 2 Amps 25OC 2.0 1 .6 1.5 Amps .4 1.0 .2 .5 .1 Single Phase, Half Wave 60Hz Resistive or Inductive Load .06 0 .04 50 75 100 0 .02 .01 .4 .6 .8 1.0 1.2 125 Average Forward Rectified Current - Amperes versus Ambient Temperature - OC 1.4 Instantaneous Forward Current - Amperes versus Instantaneous Forward Voltage - Volts Figure 3 Junction Capacitance 100 60 40 20 TJ =25OC 10 6 4 2 .1 1 .2 .4 2 Volts 1 4 175 C Volts pF 150 O 10 20 40 100 200 400 Junction Capacitance - pF versus Reverse Voltage - Volts www.cnelectr.com 1000 RGP15A thru RGP15M Figure 4 Maximum Non-Repetitive Forward Surge 60 Current 50 40 30 Amps 20 10 01 2 4 6 8 10 20 40 60 80 100 Cycles Peak Forward Surge Current - Amperes versus Number Of Cycles At 60Hz - Cycles Figure 5 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω trr +0.5A 0 Pulse Generator Note 2 25Vdc 1Ω Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive Oscilloscope Note 1 -0.25 -1.0 1cm Set Time Base for 20/100ns/cm www.cnelectr.com