® CLE400F Clairex Technologies, Inc. Four leaded Multiple Emitter Chip Surface Mount Package March, 2002 0.110 (2.81) 0.110 (2.81) 0.056 (1.42) 025 (0.63) 0.025 (0.63) 0.012 (0.30) 0.006 (0.15) 0.028 (0.71) PIN 1 MARK 2 1 2 0.006 (0.15) 4 0.056 (1.42) 0.063 (1.60) 0.275 ± 0.010 (6.99 ± 0.25) 0.063 (1.60) 0.032 (0.81) 0.075 (1.89) 3 3 1 4 0.066 0.069(0.68) (1.75) 0.038 (0.97) All dimensions are in inches (millimeters). Unless otherwise indicated, tolerance is ± 0.005 (0.12) features • ±70° emission angle • wide variety of chip combinations • wide variety of lenses and apertures absolute maximum ratings (TA = 25°C unless otherwise stated) description storage temperature........................................................................-40°C to +100°C operating temperature.....................................................................-40°C to +100°C lead soldering temperature(1)...........................................................................260°C (2) continuous forward current ..............................................................20mA/per chip peak forward current (1.0ms pulse width, 10% duty cycle) .................................. 1A reverse voltage..................................................................................................... 5V continuous power dissipation(3) .......................................................................80mW The CLE400F can contain three 850 nm IRED chips which feature double/ double heterojunction (DDH) notes: construction for increased quantum 1. For 5 seconds maximum efficiency and reliability. This device 2. Derate linearly 0.213mA/°C from 25°C free air temperature to TA = +100°C. is one example of a very broad line of 3. Derate linearly 0.85mW/°C from 25°C free air temperature to TA = +100°C. devices made possible by four leaded package configuration. One to three chips can be attached. Multiple chip devices can be series or parallel connected. Wavelengths can range from ultra-violet (390nm) through the visible spectrum into the near infrared (940nm). Also different lenses, apertures and lead configurations are available. The standard lensing is clear epoxy. electrical characteristics (TA = 25°C unless otherwise noted) symbol parameter min typ max units test conditions PO Total power output(4) 9.0 13.0 - mW VF Forward voltage - - 1.4 V IF = 20mA per chip IR Reverse current - - 10 µA VR = 5V λp Peak wavelength emission - 850 - nm IF = 20mA IF = 60mA (total cathode current) BW Spectral bandwidth at half power points - 60 - nm IF = 20mA θHP Emission angle at half power points - 140 - deg. IF = 20mA note: 4. Power output is measured in an integrating sphere. Clairex reserves the right to make changes at any time to improve design and to provide the best possible product. Clairex Technologies, Inc. Phone: 972-265-4900 1301 East Plano Parkway Fax: 972-265-4949 Revised 4/17/07 Plano, Texas 75074-8524 www.clairex.com