CLL Series Clairex ® Technologies, Inc. Photo-IC Sensors Digital Output March, 2003 1. OUTPUT 1. OUTPUT 2. VCC 2. VCC 0.500(12.7) min. 0.500(12.7) min. 0.157 (3.99) 0.210 (5.33) (3.48) 0.2100.137 (5.33) 0.190 (4.83) 0.190 (4.83) TO-72 4 4 3 0.187 (4.75) 0.187 (4.75) 0.179 (4.55) 0.179 (4.55) 3. GROUND 3. GROUND 4. ADJUST 4. ADJUST 0.048 (1.22) 0.048 (1.22) 0.028 (0.71) 0.028 (0.71) 3 2 2 0.046 (1.17) 0.046 (1.17) 0.036 (0.91) 0.036 (0.91) 1 1 0.030 (0.76) max. 0.030 (0.76) max. 0.230 (5.84) 0.230 (5.84) 0.209 (5.31) 0.209 (5.31) 0.060max (1.52) max 0.060 (1.52) CLL130 CLL131 CLL133 45°45° Case 21 0.500(12.7) min. 0.210 (5.33) 0.190 (4.83) 1. OUTPUT 3. GROUND 2. VCC 4. ADJUST TO-72 4 0.048 (1.22) 0.028 (0.71) 3 0.187 (4.75) 0.179 (4.55) 2 0.046 (1.17) 0.036 (0.91) 1 0.030 (0.76) max. 0.230 (5.84) 0.209 (5.31) 0.010 (0.25) max CLL130W CLL131W CLL133W 45° Case 22 0.500(12.7) min. features • Output stages: a. Buffer or inverter b. Open collector or internal 10KΩ pull-up • Supply voltage 4.5V to 18V • 7:1 user sensitivity adjustment on CLL130-CLL133 and CLL130W-CLL133W series • Acceptance angle: a. ± 15° high dome lens can b. ± 35° flat window lens can • Operates to 125°C • RoHS compliant description The CLL series are monolithic integrated circuits incorporating a photodiode, linear amplifier, Schmitt trigger for hysteresis and pulse shaping, and digital output with either 10KΩ pull-up or open collector. The series includes TO-72 four leaded packages (with user adjustable gain) and TO-18 three leaded packages in both high dome and flat window configurations. Alternate pin-outs are available. Contact Clairex. 0.210 (5.33) 0.190 (4.83) 1. OUTPUT 3. GROUND 2. VCC 4. ADJUST 4 0.048 (1.22) 0.028 (0.71) 3 0.187 (4.75) 0.179 (4.55) 2 0.046 (1.17) 0.036 (0.91) 1 0.030 (0.76) max. 0.230 (5.84) 0.209 (5.31) 0.060 (1.52) max CLL134 CLL135 CLL136 CLL137 45° Case 21 0.500(12.7) min. 0.210 (5.33) 0.190 (4.83) 1. OUTPUT 3. GROUND 2. VCC 4. ADJUST 4 0.048 (1.22) 0.028 (0.71) 3 0.187 (4.75) 0.179 (4.55) 2 0.046 (1.17) 0.036 (0.91) 1 0.030 (0.76) max. 0.010 (0.25) max 0.230 (5.84) 0.209 (5.31) TO-18 CLL134W CLL135W CLL136W CLL137W 45° Case 22 ALL DIMENSIONS ARE IN INCHES (MILLIMETERS) Clairex reserves the right to make changes at any time to improve design and to provide the best possible product. Clairex Technologies, Inc. Phone: 972-265-4900 TO-18 1301 East Plano Parkway Fax: 972-265-4949 Revised 3/16/06 Page 1 of 4 Plano, Texas 75074-8524 www.clairex.com CLL Series ® Clairex Technologies, Inc. Photo-IC Sensors Digital Output Schematics VREG VCC ADJ VCC VREG VOUT LA VOUT LA GND CLL133/CLL133W Open collector – inverter with Adjust VREG ADJ 10kΩ GND CLL135/CLL135W Open collector - inverter VREG VCC VCC VOUT VOUT LA LA GND GND CLL134/CLL134W Open collector - buffer CLL131/CLL131W 10kΩ pull-up – inverter with Adjust VREG ADJ 10kΩ VREG VCC VCC 10kΩ VOUT VOUT LA LA GND GND CLL137/CLL137W 10kΩ pull-up – inverter CLL130/CLL130W 10kΩ pull-up – buffer with Adjust VREG VCC 10kΩ VOUT LA GND CLL136/CLL136W 10kΩ pull-up – buffer Clairex reserves the right to make changes at any time to improve design and to provide the best possible product. Clairex Technologies, Inc. Phone: 972-265-4900 1301 East Plano Parkway Fax: 972-265-4949 Page 2 of 4 Plano, Texas 75074-8524 www.clairex.com CLL Series ® Clairex Technologies, Inc. Photo-IC Sensors Digital Output Absolute maximum ratings (TA = 25°C unless otherwise stated) storage temperature ........................................................................................................ -65°C to +150°C operating temperature ..................................................................................................... -65°C to +125°C lead soldering temperature(1) ............................................................................................................260°C VCC supply voltage...................................................................................................................4.5V to 18V VADJ (CLL130-CLL133 and CLL130W-CLL133W only) ......................................................................... 3V VOUT (10kΩ pull-up series)(2) ................................................................................................................ 18V VOUT (open collector series)(2) .............................................................................................................. 30V ISINK(3) ................................................................................................................................................ 25mA continuous power dissipation(4) ..................................................................................................... 250mW NOTES: 1. 1/16” from the case for 5 seconds maximum. 2. This rating applies when the output is in the OFF state only. 3. This rating applies when the output is in the ON state only. 4. Derate linearly 2.0mW/°C from 25°C free air to TA = 125°C. 5. CLL130-CLL133 and CLL130W-CLL133W photo-IC sensors are tested with the ADJ lead open. 6. Light source is an AlGaAs IRED with peak wavelength at 850nm. DEFINITIONS: • Ee (+) is the minimum irradiance required to cause the output to change state. • Buffer: Output is HIGH when input irradiance is >Ee (+). • Inverter: Output is LOW when input irradiance is >Ee (+). electrical characteristics (TA = 25°C unless otherwise noted) parameter symbol min typ max units test conditions Operating supply voltage VCC 4.5 - 18 Positive going threshold irradiance(6) 0.005 - 0.05 V mW/cm2 Ee (+) 0.025 - 0.25 mW/cm2 Hysteresis ratio EeT (+) EeT (-) 1.1 - 1.8 Supply current ICC - - 12 mA 4.5V ≤ VCC ≤ 18V, Ee = 0 or 0.5mW, ADJ open Total acceptance angle ΘP - 30 70 - deg. deg. All non-suffix W parts All suffix W parts 4.5V ≤ VCC ≤ 18V, ADJ open, All non-suffix W parts. All suffix W parts. operate point/release point Gain threshold can be adjusted on the CLL130-CLL133 and CLL130W-CLL133W series by placing a resistor between the ADJ and GND leads in accordance with the following table. Decreasing the resistance causes the output to switch at a higher threshold level. ADJ Resistor open 10k 4.7k 2.2k 1k Connected to GND Normalized Threshold 1.00 2.00 2.75 3.75 5.00 7.25 Clairex reserves the right to make changes at any time to improve design and to provide the best possible product. Clairex Technologies, Inc. Phone: 972-265-4900 1301 East Plano Parkway Fax: 972-265-4949 Page 3 of 4 Plano, Texas 75074-8524 www.clairex.com CLL Series ® Clairex Technologies, Inc. Photo-IC Sensors Digital Output electrical characteristics (TA = 25°C unless otherwise noted) parameter symbol min typ CLL130/CLL130W and CLL136/CLL136W (buffer, 10kΩ pull-up) max units High state output voltage VOH 4.5 - - V Low state output voltage Output rise and fall time VOL tr, tf - 75 0.4 - V ns tPHL, tPLH - 5 - µs - V Propagation delay CLL131/CLL131W and CLL137/CLL137W (inverter, 10kΩ pull-up) High state output voltage VOH 4.5 Low state output voltage VOL - - 0.4 V Output rise and fall time tr, tf - 75 - ns tPHL, tPLH - 5 - µs Propagation delay test conditions VCC = 5.0V, Ee (+) ≥ 0.5mW/cm2 VCC = 5.0V, Ee (+) = 0 VCC = 5.0V, Ee = 0 or 0.5mW/cm2, f = 10kHz, D.C. = 50%, RL = 330Ω VCC = 5.0V, Ee (+) = 0 VCC = 5.0V, Ee (+) ≥ 0.5mW/cm2 VCC = 5.0V, Ee = 0 or 0.5mW/cm2, f = 10kHz, D.C. = 50%, RL = 330Ω CLL134/CLL134W (buffer, open collector) High state output current IOH - - 100 µA Low state output voltage VOL - - 0.4 V Output rise and fall time tr, tf - 75 - ns tPHL, tPLH - 5 - µs Propagation delay VCC = 5.0V, VOH = 30V Ee (+) ≥ 0.5mW/cm2 VCC = 5.0V, Ee (+) = 0 RL = 330Ω VCC = 5.0V, Ee = 0 or 0.5mW/cm2, f = 10kHz, D.C. = 50%, RL = 330Ω CLL133/CLL133W and CLL135/CLL135W (inverter, open collector) High state output current IOH - - 100 µA Low state output voltage VOL - - 0.4 V Output rise and fall time tr, tf - 75 - ns tPHL, tPLH - 5 - µs Propagation delay VCC = 5.0V, VOH = 30V Ee (+) = 0 VCC = 5.0V, RL = 330Ω Ee (+) ≥ 0.5mW/cm2 VCC = 5.0V, Ee = 0 or 0.5mW/cm2, f = 10kHz, D.C. = 50%, RL = 330Ω NOTE: Due to the high sensitivity of the CLL series, when used in high speed switching applications, Clairex recommends installing a 0.1µF capacitor between VCC and GND. Clairex reserves the right to make changes at any time to improve design and to provide the best possible product. Clairex Technologies, Inc. Phone: 972-265-4900 1301 East Plano Parkway Fax: 972-265-4949 Page 4 of 4 Plano, Texas 75074-8524 www.clairex.com