THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS ABSOLUTE MAXIMUM RATINGS TABLE 1.0 PARAMETER Storage Temperature Supply Voltage Control Voltage UNITS MINIMUM NOMINAL MAXIMUM UNITS (Vcc) (Vc) -40 -0.5 -0.5 - 85 4.5 4.5 °C Vdc Vdc NOMINAL MAXIMUM UNITS (Fo) MINIMUM 1.544 - 20.0 1.5 MHz ppm 1 2 3 OPERATING SPECIFICATIONS NOTE ASOV3S3 TABLE 2.0 PARAMETER Center Frequency Frequency Calibration, Vc=1.48 Vdc -1.5 Frequency Stability Aging (Daily) Aging (20 Years) Total Frequency Tolerance Operating Temperature Range -0.25 -30 -2.5 -4.6 0 - 0.25 30 2.5 4.6 70 ppm ppb ppm ppm °C Vdc NOTE 4 Supply Voltage (Vcc) 3.135 3.3 3.465 Supply Current (Icc) - - 450 mA Phase Jitter (BW=12KHz to 20MHz) - - 1 ps rms Phase Jitter (BW=10Hz to 20MHz) - - 3 ps rms Period Jitter SSB Phase Noise at 10Hz offset SSB Phase Noise at 10KHz offset Warm Up Time TDEV @ 1.0 Sec. TDEV @ 4.0 Sec. - -90 -135 - 5 5 1 2 ps rms dBc/Hz dBc/Hz Minutes nS nS MINIMUM NOMINAL MAXIMUM UNITS 0.3 1.48 3.0 Vdc Frequency at Vc=0.3 Vdc -22.5 - -13.5 ppm 6 Frequency at Vc=3.0 Vdc 13.5 - 22.5 ppm 6 Slope of Frequency Adjust 5 - - ppm/V 100k - - Ohm MINIMUM NOMINAL MAXIMUM UNITS 2.6 -4 45 - - 15 0.4 4 55 6 pf Vdc Vdc mA mA % nS INTPUT CHARACTERISTICS Control Voltage Range (Vc) Input Impedance HCMOS OUTPUT CHARACTERISTICS PACKAGE CHARACTERISTICS Package PROCESS RECOMMENDATIONS Solder Reflow Wash NOTE The Connor-Winfield ASOV3S3 is a true Surface Mount 3.3V Oven Controlled Crystal Oscillator (OCXO) with an HCMOS output. The ASOV3S3 is designed for Stratum 3 applications requiring tight frequency stability and low jitter. (Voh) (Vol) (Ioh) (Ioh) 50 - FEATURES FREQUENCY ADJUST 3.3V OPERATION TABLE 4.0 PARAMETER (High) (Low) Current (High) (Low) Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% 5 DESCRIPTION TABLE 3.0 PARAMETER LOAD Voltage CW 0107 ASOV3S3 12.80M SURFACE MOUNT 3.3V HCMOS STRATUM 3 OCXO NOTE LOW JITTER <1pS RMS TEMPERATURE STABILITY ±0.25ppm FREQUENCY TOLERANCE OF ±4.6ppm OVER TWENTY YEARS SURFACE MOUNT PACKAGE TABLE 5.0 Surface Mount, Non-hermetic package consisting of an FR4 substrate with grounded metal cover. TABLE 6.0 The component solder used internal to this device has a mel ting point of 221°C. The peak temperature inside the device should be less than or equal to 220°C for a maximum of 10 seconds Ultrasonic cleaning is not recommended Notes: 1) 2) 3) 4) Initial calibration @ 25°C, Vc=1.48 Vdc. Frequency vs. temperature stability, 0 to 70°C absolute. At the time of shipment after48 hours of operation. Inclusive of calibration, operating temperature range, supply voltage change, load change, shock and vibration, 20 years aging, Vc=1.48 Vdc. 5) Measured @ 25°C, within 5 minutes, the unit will be within +/-0.1ppm of its reference frequency, measured after 30 minutes of continuo us operation at a stable 25°C 6) Referenced to Fo @ 25°C, Positive Transfer Characteristic TAPE AND REEL PACKAGING ORDERING INFORMATION ASOV3S3 - 12.80MHz OCXO SERIES CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: Cx019 PAGE 1 OF 2 REV: 05 DATE: 11/12/04 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS ENVIRONMENTAL CHARACTERISTICS Temperature Cycle: Per MIL-STD-883, Method 1010, Condition B. -55°C to 125°C, 20 cycles,10 minute dwell, 1m inute transition. Gross Leak Test: Per MIL-STD-202, Method 112, Condition D. No bubbles in flourinert (FC-43) at 125°C ±5°C for 20 seconds. SOLDERING Pin Solderability: Per MIL-STD-883, Method 2003. 8 hour steam age prior to 245°C ±5°C Solder pot dip, 95% Coverage. Resistance to Solder Heat: Per MIL-STD-202, Method 210, Condition C. Wave: Topside board -mount product, 260°C ±5°C for 20 Seconds. MECHANICAL CHARACTERISTICS Vibration: Per MIL-STD-202, Method 204, Condition A. 10G’s peak, 10Hz to 500Hz, 15minut e cycles 12 times each perpendicular axis. Shock: Per MIL-STD-202, Method 213, Condition D. 500G’s, 1ms, half sine, 3 shocks per direction. Moisture Resistance: Per MIL-STD-202, Method 106. 95% RH @ 65°C, 10 cycles 10°C to 65°C. PIN FUNCTION .330 max (8.382mm) CW DATE CODE ASOV3S3 12.80M 1 7 8 14 CONTROL VOLTAGE GROUND (CASE) OUTPUT Vcc Dimensional Tolerance: ±.005 (.127mm) KEEP OUT AREA 90% .830 (21.08mm) 50% 10% .565 (14.35mm) CONTROL VOLTAGE 3.0Vdc POWER SUPPLY 3.3Vdc 14 8 1 7 Specifications subject to change without notice. DATA SHEET #: Cx019 PAGE 2 OF 2 REV: 05 DATE: 11/12/04 aCopyright 2001 Connor-Winfield all rights reserved.