THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. WWW.CONWIN.COM PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS 14 PIN DIP 3.3V LVMOS STRATUM 3 OCVCXO CW 0730 OVA3AB1AA 19.44MHZ ABSOLUTE MAXIMUM RATINGS PARAMETER TABLE 1.0 UNITS MINIMUM NOMINAL MAXIMUM UNITS -40 - 85 °C Storage Temperature Supply Voltage (Vcc) -0.5 - 4.5 Vdc Control Voltage (Vc) -0.5 - 4.5 Vdc NOTE OVA3AB1AA DESCRIPTION OPERATING SPECIFICATIONS TABLE 2.0 PARAMETER Center Frequency (Fo) MINIMUM 1.544 NOMINAL MAXIMUM UNITS - 20.0 1.5 MHz NOTE Frequency Calibration, Vc=1.48 Vdc -1.5 ppm 1 Frequency Stability Aging (Daily) Aging (20 Years) Total Frequency Tolerance Operating Temperature Range -30 -2.5 -4.6 0 - 0.25 30 2.5 4.6 70 ppm ppb ppm ppm °C 2 3 Vdc Supply Voltage (Vcc) 3.135 3.3 3.465 Supply Current (Icc) - - 450 mA Phase Jitter (BW=12KHz to 20MHz) - - 1 ps rms Phase Jitter (BW=10Hz to 20MHz) - - 3 ps rms Period Jitter SSB Phase Noise at 10Hz offset SSB Phase Noise at 10KHz offset Start Up Time: Oscillator Warm Up Time TDEV @ 1.0 Sec. TDEV @ 4.0 Sec. - -90 -150 - 5 35 5 1 2 ps rms dBc/Hz dBc/Hz mS Minutes nS nS MINIMUM NOMINAL MAXIMUM UNITS 0.3 -22.5 13.5 10 100k 1.48 - 3.0 -13.5 22.5 - Vdc ppm ppm ppm/V Ohm NOMINAL - MAXIMUM 15 0.4 UNITS pf Vdc Vdc - mA 50 - 4 55 6 mA % nS INPUT CHARACTERISTICS PARAMETER Control Voltage Range Frequency at Vc=0.3 Vdc Frequency at Vc=3.0 Vdc Slope of Frequency Adjust Input Impedance (Vc) LVMOS OUTPUT CHARACTERISTICS (Voh) (Vol) MINIMUM 2.6 - Current (Ioh) -4 (Ioh) 45 - (Low) Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% FEATURES VOLTAGE CONTROLLED FREQUENCY ADJUST TABLE 3.0 NOTE LOW JITTER <1pS RMS FREQUENCY STABILITY: 0.25ppm 6 6 OVERALL FREQUENCY TOLERANCE: ±4.6ppm OVER TWENTY YEARS TEMPERATURE RANGE: 0 to 70°C NOTE HERMETICALLY SEALED 14 PIN PACKAGE RoHS COMPLIANT / LEAD FREE ORDERING INFORMATION OVA3AB1AA TABLE 5.0 PACKAGE CHARACTERISTICS Package 3.3V OPERATION 5 TABLE 4.0 PARAMETER LOAD Voltage (High) (Low) (High) 4 The Connor-Winfield OVA31AB1AA is a hermetically sealed 14 Pin DIP 3.3V Oven Controlled Voltage controlled Crystal Oscillator (OCVCXO) with an LVMOS output. The OVA31AB1AA is designed for Stratum 3 applications requiring low jitter and tight frequency stability. 14 pin DIP, hermetically sealed, grounded case, welded package OCXO SERIES - 019.44M CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: Cx128 PAGE 1 OF 2 REV: 00 DATE: 07/11/07 aCopyright 2007 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. HTTP://WWW.CONWIN.COM PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS Notes: 1) 2) 3) 4) Initial calibration @ 25C, Vc=1.48 Vdc. Frequency stability vs. change in temperature, 0 to 70C, peak to peak. At the time of shipment after48 hours of operation. Inclusive of calibration, operating temperature range, supply voltage change, load change, shock and vibration, 20 years aging, Vc=1.48 Vdc. 5) Measured @ 25C, within 5 minutes, the unit will be within +/-0.1ppm of its reference frequency, measured after 30 minutes of continuous operation at a stable 25C 6) Referenced to Fo @ 25C, positive transfer characteristic. ENVIRONMENTAL CHARACTERISTICS Temperature Cycle: Per MIL-STD-883, Method 1010, Condition B. -55°C to 125°C, 10 cycles, 10 minute dwell, 1minute transition. Gross Leak Test: Per MIL-STD-202, Method 112, Condition D. No Bubbles in flourinert (FC-43) at 125°C ±5°C for 20 seconds. SOLDERING Pin Solderability: Per MIL-STD-883, Method 200. 8 hour steam age prior to 254°C ±5°C Solder pot dip, 95% Coverage. Resistance to Solder Heat: Per MIL-STD-202, Method 210, Condition C. Wave: Topside boardmount product, 260°C ±5°C for 20 seconds. MECHANICAL CHARACTERISTICS Vibration: Per MIL-STD-202, Method 204, Condition A. 10G’s peak, 10Hz to 500Hz, 15 minute cycles 12 times each perpendicular axis. Shock: Per MIL-STD-202, Method 213, Condition F. 1500G’s, 0.5ms, half sine, 3 shocks per direction. Moisture Resistance: Per MIL-STD-202, Method 106. 95% RH @ 65°C, 10 cycles 10°C to 65°C. Pin Connections Pin 1 7 8 14 Package Outline Connection Control Voltage Ground (Case) Output Vcc Output Waveform 90% 50% 10% Dimensional Tolerance: ±.005 (.127mm) Test Circuit Solder Profile Temperature 260°C 260°C 220°C 180°C 150°C 3.0Vdc 3.3Vdc 14 8 1 7 120°C 0 120 S Max. Time 10 S 60 S Max. 360 Sec. Max. Specifications subject to change without notice. DATA SHEET #: Cx106 PAGE 2 OF 2 REV: 00 DATE: 10/23/06 aCopyright 2007 Connor-Winfield all rights reserved.