The 8560AS is intended for use as an RF amplifier or oscillator or in audio amplifier or modulation service. It has electrical characteristics similar but not identical to the 4CX250B/7203. The 8560AS is designed for conduction cooling and is nominally rated for 200 watts anode dissipation. Class of Operation Characteristics Plate Dissipation (Max.) Screen Dissipation (Max.) Grid Dissipation (Max.) Frequency for Max. rating (CW) Amplification Factor Filament/Cathode Voltage Current Capacitance Input Output Feedthrough Capacitance Input Output Feedthrough Cooling Base Air Socket Air Chimney Boiler Length Diameter Weight Maximum Ratings Type of Service Plate Voltage (Volts) Plate Current (Amps) 200 Watts 12 Watts 2 Watts 500 MHz 5 Oxide Coated 6.3 Volts 2.6 Amps Grounded Cathode 16.5 pf 4.6 pf .04 pf ----- pf --- pf --- pf Conduction 9 Pin Special n/a ----2.45 in; 62.1 mm 1.63 in; 41.4 mm 8.2 oz; 235 gm T ypical Operation Plate Screen Voltage Voltage (Volts) (Volts) Plate Current (Amps) Drive Output Power Power (Watts) (kiloWatts) C RF amplifier 2,000 0.25 2,000 250 0.25 2.9 0.390 C RF amplifier plate modulated 1,500 0.20 1,500 250 0.20 1.7 0.235 AB1 RF linear amplifier 2,000 0.25 2,000 350 0.25 --- 0.300 AB1 RF amplifier or modulator 2,000 0.25 2,000 350 0.50 --- 0.600 The values listed above represent specified limits for the product and are subject to change. The data should be used for basic information only. Formal, controlled specifications may be obtained from CPI for use in equipment design. For information on this and other CPI products, visit our website at: www.cpii.com, or contact: CPI MPP Division, Eimac Operation, 607 Hansen Way, Palo Alto, CA 94303 telephone : 1(800) 414-8823. fax : (650) 592-9988 | email : [email protected] CPI | 8560AS CPI | 4CW50,000J 8560AS