Embedded Power for Business-Critical Continuity Rev. 09.29.09_82 DS450/DS550 of 4 DS450-3/DS550-3 450 W - 550 W Distributed Power System Distributed Power Bulk Front-End Total Output Power: 450 - 550 Watts +12 Vdc Main Output +3.3 Vdc Stand-by Output Wide Range Input Voltage: 90 - 264 Vac Electrical Specifications Special Features Input Input range: 90 - 264 Vac (wide range) • • • • • • • • • • • • • • • • • • • • Frequency: Inrush current: 47 - 63 Hz, single phase AC Active Power Factor Correction EN61000-3-2 Harmonic Compliance Active AC Inrush Control 1U X 2U Form Factor 10.3 W / in3 (DS550) 8.4 W / in3 (DS450) +12 Vdc Output +3.3 Vdc Stand-By No Minimum Load Required Hot Plug Operation N + 1 Redundant Internal OR’ing Fets Active Current Sharing Built-in Cooling Fans (40 mm x 28 mm) I2C Communication Interface Bus EERPOM for FRU Data Amber LED Status, Fan_Fail Green LED Status, Power Good / AC_OK Status Internal Fan Speed Control Fan Fail Tach Output Signal One Year Warranty Efficiency: 15 A maximum > 84% typical at full load, high line Conducted EMI: FCC Subpart J EN55022 Class A Radiated EMI: FCC Subpart J EN55022 Class A Power factor: 0.99 typical Leakage current: 1.30 mA @ 240 Vac Hold up time: 20 ms minimum Output Main DC voltage: +12 V Stand-By: +3.3 Vsb Adjustment range: Factory Set, no pot adjustments Regulation: +12 Vdc; +5%/-3% +3.3 Vsb; +5%/-4% Overcurrent: See Table 1 next page +12 Vdc; 13.5 - 15 Vdc +3.3 Vsb; 3.76 - 4.30 Vdc Overvoltage: Undervoltage: Turn-on delay: +12 V Output Rise Time: Safety • • • • • UL/cUL 60950 (UL Recognized) NEMKO+ CB Report EN60950 EN60950 CE Mark China CCC +12 Vdc; 11.0 - 11.5 Vdc +3.3 Vsb; 2.77 - 3.00 Vdc 1 Second max 2 - 20 mS, Monotonic Embedded Power for Business-Critical Continuity Rev. 09.29.09_82 DS450/DS550 of 4 Logic Control PS Inhibit: When supply is inserted into the system the pin is pulled LOW and power supply is ON after all other pins are seated I2C port P6. When the power supply is on and running normal P6 is low. When the power supply is off, either due to -PS_ON, PS_KILL, or a fault, then P6 is high. PS_Status: AC_Pfail: I2C port P7. P7 is high except when the power supply turns the main outputs, not +3.3 Vsb, off due to an AC failure (AC missing or too low for power supply operation). If the supply is turned off due to -PS_ON, PS_KILL, or a fault, then P7 remains high. Fan_Fault: Tach_1: The PSU will provides an open collector Tach 1 output. This signal is generated from the fan. The signal should generate 2 pulses per revolution. The logic in the system will be operating at 3.3 V. Environmental Specifications Operating temperature: -10 °C to 50 °C Storage temperature: Altitude, operating: -40 °C to +70 °C 10,000 ft. Electromagnetic -EN61000-3-2, -3-3 susceptibility / Input transients: -EN61000-4-2, 4.3, 4-4, -4-5, 4-11 Level -EN55024:1998 RoHS & lead-free compliant (no tantalum caps) Humidity: 20 to 90% RH, non-condensing Shock and vibration specificatons complies with Emerson Network Power Std. Specification, Q3205 MTBF (Demonstrated): 400K Hrs at full load, 40 °C Ordering Information Output DS450-3 DS550-3 Nominal Output Voltage Set Point 12.0 Vdc 3.3 Vsb 12.0 Vdc 3.3 Vsb Set Point Total Tolerance Regulation ± 0.2% +5 / -3% ± 1% +5 / -4% ± 0.2% +5 / -3% ± 1% +5 / -4% Minimum Current 0A 0A 0A 0A Maximum Current 37.0 A 3.0 A 45.0 A 3.0 A *Overcurrent latches off if overcurrent lasts over 1 second, otherwise it is auto recovery. *For 5 Vsb, consult marketing. Output Ripple P/P 120 mV 60 mV 120 mV 60 mV Overcurrent 39.5 A - 44.4 A 4.9 A Avg, 7 A max 48.0 A - 54.0 A 4.9 A Avg, 7 A max .1496" ±.02" (3.8 ±0.5) 1.575" ±0.3" (40.0 ±0.8) 3.071" ±.03" (78.0 ±0.8) 2.913" ±.024") (74.0 ±0.6) 2.84" (72.2) .228 ±.02 (5.8 ±0.5) .197" ±.02" (5.0 ±0.5) 1.51" ±.03" (38.4 ±0.8) 3.07" (78.0) 1.52" (38.4) J .972" ±0.2" 24.7 ±0.5 13.29" (337.6) 12.03"±0.3" (305.6 ±0.8) 10.88" (276.4) 10.02" (254.7) H STD AIRFLOW (3X) 254.6 10.02" (254.6) 11.925" ±0.3" (302.9 ±0.8) K (3X) 10.02" (254.7) (2X) 41.5 LATCH SPRING DISTANCE (REF.) G F F F F E 3.0 ±0.3 C B 1.453" (36.9) D .138" ±.020" (3.5 ±0.5) .3976" ±.028" (10.1 ±0.5) A 'AC GOOD' GREEN 'FAULT' YELLOW 'POWER GOOD' GREEN Embedded Power for Business-Critical Continuity Mechanical Drawing Rev. 09.29.09_82 DS450/DS550 of 4 Embedded Power for Business-Critical Continuity Americas 5810 Van Allen Way Carlsbad, CA 92008 USA Telephone:+1 760 930 4600 Facsimile: +1 760 930 0698 DC Output Connector Pinout Assignment Male connector as viewed from the rear of the supply: D1 D2 D3 D4 D5 D6 C1 C2 C3 C4 C5 C6 B1 B2 B3 B4 B5 B6 A1 A2 A3 A4 A5 A6 PB1 PB2 PB3 PB4 PB5 PB6 P1 - Power Supply Side 1.FCI Power Blade 51721 series 51721-10002406AA 2.Molex Power Connector SD-87667 series 87667-7002 Mating Connector (System Side) 1.FCI Power Blade 51741-10002406CC Strait Pins 2.FCI Power Blade 51761-10002406AA Right Angle Rev. 09.29.09_82 DS450/DS550 of 4 Europe (UK) Pin Signal Name PB 1 PB 2 PB 3 PB 4 PB 5 PB 6 A1 A2 A3 A4 A5 A6 B1 B2 B3 B4 B5 B6 C1 C2 C3 C4 C5 C6 D1 D2 D3 D4 D5 D6 +12 V Return +12 V Return +12 V Return +12 V +12 V +12 V PS_KILL +12 V_Current Share Logic Return +3.3 V Stand-By A0 (I2C Address BIT 0 Signal) +3.3V Stand-By Logic Return Spare Logic Return +3.3 V Stand-By SDA (I2C Data Signal) PSON (Power Enable Signal) Logic Return Tach_1 (Fan Fail Signal) Logic Return +3.3 V Stand-By SCL (I2C Clock Signal) VIN_GOOD (AC Input present) -PS_Present (Power Supply Seated) Spare Logic Return +3.3 V Stand-By S_INT (Alert) POK (Output Power Ok) Waterfront Business Park Merry Hill, Dudley West Midlands, DY5 1LX United Kingdom Telephone:+44 (0) 1384 842 211 Facsimile: +44 (0) 1384 843 355 Asia (HK) 14/F, Lu Plaza 2 Wing Yip Street Kwun Tong, Kowloon Hong Kong Telephone:+852 2176 3333 Facsimile: +852 2176 3888 For global contact, visit: www.PowerConversion.com techsupport.embeddedpower @emerson.com While every precaution has been taken to ensure accuracy and completeness in this literature, Emerson Network Power assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or omissions. Emerson Network Power. The global leader in enabling business-critical continuity. AC Power Connectivity DC Power Embedded Computing Embedded Power Monitoring Outside Plant Power Switching & Controls Precision Cooling Racks & Integrated Cabinets Services Surge Protection EmersonNetworkPower.com Emerson Network Power and the Emerson Network Power logo are trademarks and service marks of Emerson Electric Co. ©2009 Emerson Electric Co.