ANU-48 ANU-48 LED Driver Module Description The ANU-48 LED Driver Module is used in conjunction with the Gamewell-FCI E3 Series® Expandable Emergency Voice Evacuation System and provides output for up to eight (8), remote panel switches and forty-eight (48), remote LEDs, contributing to the versatility and flexibility of the Gamewell-FCI System. The switches may be programmed as a Speaker Circuit Switch, a Fire Fighter Phone Switch, or an Auxiliary Control Switch, using a bank of three (3), switches (one each for On-Off-Auto functions). Switches may also be programmed with custom defined functions such as: System Silence, Alarm Acknowledge, Trouble Acknowledge, Lamp Test, Alarm Tone On, Manual Select, Drill and System Reset/LED etc. Output is also provided for Alarm, Supervisory, System Trouble, Power Fault, System Silenced, NAC #1 Silenced and NAC #2 Silenced LEDs. While Underwriters Laboratories Standards only address testing at ambient temperatures down to 32° F, the ANU-48 is Factory Mutual Approved at an ambient of -40° F/C (non-condensing). When powered externally, each driver circuit provides a maximum of .050 amp. with a maximum of 2.4 amperes per ANU-48 module. Note: If more than four (4), ANU-48 modules are installed, an external regulated and power-limited power supply, Listed for use with fire protective signaling units, is required. ANU-48 Features • Listed under UL Standard 864, 9th Edition • Input for eight (8), software programmable switches, maintained or momentary contact • Output for up to forty-eight (48), remote LEDs or driver circuits • INI-VG and ILI-MB-E3 can support up to sixteen (16), ANU-48 LED driver modules or ASM-16 switch modules for a total of 128 switches and 768 LEDs • May be located up to 3,000 feet from the control panel, and up to fifteen (15), additional annunciators can be connected • Adaptable to be mounted in any remotely located UL Listed annunciator enclosure Ordering Information Specifications Model ANU-48 Operating Voltage: 24 VDC resettable Operating Current: 0.011 amp.* Operating Temperature: 32° to 120° F (0° to 49° C) Relative Humidity: 0 to 93%, (non-condensing) at 90° F (32° C) *Add .003 amp. for any LED to be lit for any condition when powered internally. When powered externally, each driver circuit provides a maximum of 0.050 amp. with a maximum of 2.4 amps. per ANU-48 sub-assembly. (48 circuits). ® E3 Series is a registered trademark of Honeywell International Inc. Description Remote LED Driver Module An ISO 9000-2000 Company City of Chicago SIGNALING FM APPROVED S1869 3017416 Approved City of Class 1 DENVER Approved 7300-0694:257 Class 2 High Rise GAMEWELL-FCI 12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: (203) 484-7161 • Fax: (203) 484-7118 Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use. www.gamewell-fci.com 9020-0596 Rev. f2 page 1 of 1 ©2007 by Honeywell International Inc. All rights reserved.