DACT-E3 Description Digital Alarm Communicator Transmitter The Digital Alarm Communicator Transmitter (DACT-E3) is an optional component of the E3 Series® Expandable Emergency Evacuation System. The DACT-E3 sends digital signals over the telephone network to a central station. This module can be located in the main cabinet or remotely located via a local RS-485 serial interface. The DACT-E3 is compatible with digital alarm communicator receivers (DACRs) that receive the following signaling formats: • SIA DC8 • 3+1 2300 Hz • SIA DCS20 • 4+2 1400 Hz • Ademco Contact ID • 4+2 2300 Hz • 3+1 1400 Hz In addition to the DACT-E3 being compatible with digital signaling formats, the DACT-E3 features numerous formats for communication to a central station. As a digital communicator, the DACT-E3 complies with FCC Part 8, Telecommunication Standards for DC and AC Ringer Equivalence. DACT-E3 Features • Listed under UL Standard 864, 9th Edition • Communicates with the E3, ILI-MB-E3 sub-assembly via RS-485 Installation Instructions The DACT-E3 is adaptable for installation in standard E3 Series® System cabinets. Typically, the DACT-E3 module mounts on standoffs on top of the left side of the ILI-MB-E3 module. Either unit can be easily connected to the backbox or sub-assembly plate depending on the cabinet module. • Communicates in a variety of formats Note: For instructions on installing the DACT-E3, refer to • Traces proper central station “ACK” and “Kiss-off” tone the E3 Series® Expandable Emergency Evacuation Installation/Operating Manual, Part Number: 9020-0574 or the DACT-E3 Installation Instructions Part Number:9000-0580. Specifications Operating Voltage: 24 VDC (from PM-9 power supply) Operating Current: 0.018 amp. Alarm Current: 0.018 amp. Operating Temperature: 32° to 120° F (0 to 49° C) Relative Humidity: 0 to 93%, non-condensing at 90° F (32° C) • Transmits and verifies data to the central station • Offers pre-programmed dialing to the central station phone number • Performs on and off-hook status to the phone lines • Activates hang-up and release phone lines Ordering Information Model Description DACT-E3 Digital alarm communicator transmitter An ISO 9000-2000 Company SIGNALING E3 Series® and NetSOLO® are registered trademarks of Honeywell International Inc. S1869 FM MEA APPROVED Approved 3025415 231-06-E 7165-0694:268 7165-0694:269 City of Chicago Approved Class 1 Class 2 High Rise City of Denver Approved GAMEWELL-FCI 12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: (203) 484-7161 • Fax: (203) 484-7118 Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use. www.gamewell-fci.com 9020-0610 Rev. e1 page 1 of 1 ©2007 by Honeywell International Inc. All rights reserved.