RG1J SINTERED GLASS JUNCTION FAST SWITCHING RECTIFIER VOLTAGE: 600V CURRENT: 1.0A FEATURE SOD-57 High temperature metallurgically bonded construction Sintered glass cavity free junction Capability of meeting environmental standard of MIL-S-19500 High temperature soldering guaranteed 350°C /10sec/0.375”lead length at 5 lbs tension Operate at Ta =55°C with no thermal runaway Fast switching for high efficiency MECHANICAL DATA Case: SOD-57 sintered glass case Terminal: Plated axial leads solderable per MIL-STD 202E, method 208C Polarity: color band denotes cathode end Mounting position: any Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half wave, 60HZ, resistive or inductive load rating at 25°C, unless otherwise stated) SYMBOL RG1J units Maximum Recurrent Peak Reverse Voltage Vrrm 600 V Maximum RMS Voltage Vrms 420 V Maximum DC blocking Voltage Vdc 600 V Maximum Average Forward Rectified Current 3/8”lead length at Ta =55°C Peak Forward Surge Current 8.3ms single half sinewave superimposed on rated load Maximum Forward Voltage at rated Forward Current and 25°C Maximum full load reverse current full cycle average 0.375”(9.5MM) lead length at Ta=100°C Maximum DC Reverse Current Ta =25°C at rated DC blocking voltage Ta =125°C If(av) 1.0 A Ifsm 30 A Vf 1.3 V Ir(av) 100 µA Ir 2.0 100 µA Typical Reverse Recovery Time (Note 1) Trr 200 nS Typical Junction Capacitance (Note 2) Cj 15 pF Typical Thermal Resistance (Note 3) Rth(ja) 55 °C /W Tstg, Tj -65 to +175 °C Storage and Operating Temperature Range Note: 1. Reverse Recovery Condition If =0.5A, Ir =1.0A, Irr =0.25A 2. Measured at 1.0 MHz and applied reverse voltage of 4.0Vdc 3. Thermal Resistance from Junction to Ambient at 3/8”lead length, P.C. Board Mounted Rev.A1 www.gulfsemi.com RATINGS AND CHARACTERISTIC CURVES RG1J Rev.A1 www.gulfsemi.com