RMD01 SINGLE PHASE GLASS PASSIVATED FAST RECOVERY SURFACE MOUNT BRIDGE RECTIFIER VOLTAGE: 100V CURRENT:0.8A FEATURE MDF For surface mount application Reliable low cost construction utilizing molded plastic Technique Surge overload rating: 30A peak MECHANICAL DATA Terminal: Plated leads solderable per MIL-STD 202E, method 208C Case: UL-94 Class V-0 recognized Flame Retardant Epoxy Polarity: Polarity symbol marked on body Mounting position: any Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half -wave, 60HZ, resistive or inductive load rating at 25°C, unless otherwise stated, for capacitive load, derate current by 20%) SYMBOL RMD01 Units Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC blocking Voltage Maximum Average Forward Rectified Current at Ta =40°C Peak Forward Surge Current 8.3ms single half sine-wave superimposed on rated load Maximum Instantaneous Forward Voltage at forward current 0.4A Maximum Reverse Recovery Time (Note 1) Vrrm Vrms VDC 100 70 100 V V V If(av) 0.8 A Ifsm 30.0 A Vf 1.3 V Trr nS Maximum DC Reverse Current Ta =25°C at rated DC blocking voltage Ta =125°C Typical Junction Capacitance (Note 2) Storage and Operating Junction Temperature Ir 150 5.0 500.0 15.0 -55 to +150 Cj Tj, Tstg µA uA pF °C Note: 1. Reverse Recovery Condition If =0.5A, Ir =1.0A, Irr =0.25A 2. Measured at 1.0 MHz and applied voltage of 4.0 volt Rev.A1 www.gulfsemi.com RATINGS AND CHARACTERISTIC CURVES RMD01 Rev.A1 www.gulfsemi.com