TECHNICAL DATA SHEET 6 Lake Street, Lawrence, MA 01841 1-800-446-1158 / (978) 620-2600 / Fax: (978) 689-0803 Website: http: //www.microsemi.com NPN POWER SILICON TRANSISTOR Qualified per MIL-PRF-19500/464 DEVICES LEVELS 2N5685 2N5686 JAN JANTX JANTV ABSOLUTE MAXIMUM RATINGS (TC = +25°C unless otherwise noted) Parameters / Test Conditions Symbol 2N5685 2N5686 Unit Collector-Emitter Voltage VCEO 60 80 Vdc Collector-Base Voltage VCBO 60 80 Vdc Emitter-Base Voltage VEBO 5.0 5.0 Vdc Base Current IB 15 15 Adc Collector Current IC TJ, Tstg 50 50 300 300 171 171 -55 to +200 Adc W W °C Symbol Max. Unit RθJC .0584 °C/W @ TC = +25°C (1) Total Power Dissipation @ TC = +100°C (1) Operating & Storage Junction Temperature Range PT TO-3 (TO-204AE) THERMAL CHARACTERISTICS Parameters / Test Conditions Thermal Resistance, Junction-to-Case Note: 1. Derate linearly 1.715 W/°C between TC = 25°C and TC = 200°C ELECTRICAL CHARACTERISTICS (TA = +25°C, unless otherwise noted) Parameters / Test Conditions Symbol Min. Max. Unit OFF CHARACTERTICS (1) Collector-Emitter Breakdown Voltage IC = 100mAdc Collector-Emitter Cutoff Current VCE = 30Vdc VCE = 40Vdc Collector-Emitter Cutoff Current VCE = 60Vdc, VBE = 1.5Vdc VCE = 80Vdc, VBE = 1.5Vdc Collector-Base Cutoff Current VCE = 60Vdc VCE = 80Vdc Emitter-Base Cutoff Current VEB = 5.0Vdc T4-LDS-0162 Rev. 1 (100546) 2N5685 2N5686 V(BR)CEO 2N5685 2N5686 ICEO 500 500 2N5685 2N5686 ICEX 10 10 μAdc 2N5685 2N5686 ICBO 2.0 2.0 mAdc IEBO 1.0 mAdc Vdc 60 80 μAdc Page 1 of 3 TECHNICAL DATA SHEET 6 Lake Street, Lawrence, MA 01841 1-800-446-1158 / (978) 620-2600 / Fax: (978) 689-0803 Website: http: //www.microsemi.com ELECTRICAL CHARACTERISTICS (TA = +25°C, unless otherwise noted) Parameters / Test Conditions Symbol Min. Max. hFE 30 15 5.0 60 Unit (2) ON CHARACTERISTICS Forward-Current Transfer Ratio IC = 5.0Adc, VCE = 2.0Vdc IC = 25Adc, VCE = 2.0Vdc IC = 50Adc, VCE = 5.0Vdc Collector-Emitter Saturation Voltage IC = 25Adc, IB = 2.5Adc IC = 50Adc, IB = 10Adc Base-Emitter Saturation Voltage IC = 25Adc, IB = 2.5Adc Base-Emitter Voltage IC = 25Adc, VCE = 2.0Adc VCE(sat) 1.0 5.0 Vdc VBE(sat) 2.0 Vdc VBE(ON) 2.0 Vdc Min. Max. Unit 2.0 20 DYNAMIC CHARACTERISTICS Parameters / Test Conditions Magnitude of Common Emitter Small-Signal Short-Circuit, Forward Current Transfer Ratio IC = 5.0Adc, VCE = 10Vdc, f = 1.0MHz Small-Signal Short-Circuit Forward Current Transfer Ratio IC = 10Adc, VCE = 5.0Vdc, f = 1.0kHz Output Capacitance VCB = 10Vdc, IE = 0, 0.1MHz ≤ f ≤ 1.0MHz Symbol |hfe| hfe 15 Cobo 1200 pF Max. Unit SWITCHING CHARACTERISTICS Parameters / Test Conditions Symbol Min. Turn-On Time VCC = 30Vdc; IC = 25Adc; IB1 = 2.5Adc ton 1.5 μs Turn-Off Time VCC = 30Vdc ; IC = 25Adc; IB1 = -IB2 = 2.5Adc toff 3.0 μs SAFE OPERATING AREA DC Tests TC = +25°C, 1 Cycle, t = 1.0s Test 1 VCE = 6.0Vdc, IC = 50Adc Test 2 VCE = 30Vdc, IC = 10Adc Test 3 VCE = 50Vdc, IC = 560mAdc VCE = 60Vdc, IC = 640mAdc 2N5685 2N5686 (2) Pulse Test: Pulse Width = 300µs, Duty Cycle ≤ 2.0% T4-LDS-0162 Rev. 1 (100546) Page 2 of 3 TECHNICAL DATA SHEET 6 Lake Street, Lawrence, MA 01841 1-800-446-1158 / (978) 620-2600 / Fax: (978) 689-0803 Website: http: //www.microsemi.com PACKAGE DIMENSIONS Ltr CD CH HR HR1 HT LD LL L1 MHD MHS PS PS1 S1 Dimensions Inches Millimeters Min Max Min Max .875 22.22 .250 .450 6.35 11.43 .495 .525 12.57 13.34 .131 .188 3.33 4.78 .060 .135 1.52 3.43 .057 .063 1.45 1.60 .312 .500 7.92 12.70 .050 1.27 .151 .165 3.84 4.19 1.177 1.197 29.90 30.40 .420 .440 10.67 11.18 .205 .225 5.21 5.72 .655 .675 16.64 17.15 Notes 3 6 4, 5, 9 4, 5, 9 5, 9 7 5 NOTE: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. * 11. Dimensions are in inches. Millimeters are given for general information only. Body contour is optional within zone defined by CD. These dimensions shall be measured at points .050 inch (1.27 mm) to .055 inch (1.40 mm) below seating plane. When gauge is not used, measurement shall be made at seating plane. Both terminals. At both ends. Two holes. The collector shall be electrically connected to the case. LD applies between L1 and LL. Lead diameter shall not exceed twice LD within L1. In accordance with ASME Y14.5M, diameters are equivalent to φx symbology. Terminal 1 is emitter; terminal 2 is base; case is collector. * FIGURE 1. Physical dimensions (TO-3) T4-LDS-0162 Rev. 1 (100546) Page 3 of 3