ASP-150 150W Single Output with PFC Function series Features : Universal AC input / Full range Built-in active PFC function, PF>0.95 Protections: Short circuit / Overload / Over voltage / Over temperature Cooling by free air convection High power density 8.4w/in3 100% full load burn-in test No load power consumption<1W@240VAC ZCS/ZVS technology to reduce power dissipation 3 years warranty SPECIFICATION MODEL ASP-150-12 ASP-150-15 ASP-150-20 ASP-150-24 DC VOLTAGE 12V 15V 20V 24V 48V RATED CURRENT 11A 9.5A 7.5A 6.3A 3.2A CURRENT RANGE 0 ~ 11A 0 ~ 9.5A 0 ~ 7.5A 0 ~ 6.3A 0 ~ 3.2A RATED POWER 132W 142.5W 150W 151.2W 153.6W 180mVp-p 200mVp-p 240mVp-p 240mVp-p 14 ~ 17V 17 ~ 22V 22 ~ 27V 45.6 ~ 52.8V RIPPLE & NOISE (max.) Note.2 150mVp-p OUTPUT INPUT VOLTAGE ADJ. RANGE Fixed. Can be modified between the range above by factory VOLTAGE TOLERANCE Note.3 2.0% 2.0% 1.0% 1.0% 1.0% LINE REGULATION 0.5% 0.5% 0.5% 0.5% 0.5% LOAD REGULATION 1.0% 1.0% 0.5% 0.5% 0.5% SETUP, RISE TIME 3000ms, 80ms at full load HOLD UP TIME (Typ.) 50ms/230VAC VOLTAGE RANGE 90 ~ 264VAC FREQUENCY RANGE 47 ~ 63Hz POWER FACTOR (Typ.) PF 0.95/230VAC EFFICIENCY (Typ.) 88% AC CURRENT (Typ.) INRUSH CURRENT (Typ.) 2A/115VAC LEAKAGE CURRENT OVERLOAD PROTECTION OVER VOLTAGE OVER TEMPERATURE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS WITHSTAND VOLTAGE SAFETY & EMC (Note 4) OTHERS 16ms/115VAC at full load 127 ~ 370VDC PF 0.98/115VAC at full load 88% 90% 90% COLD START 80A/230VAC <2mA / 240VAC 105 ~ 135% rated output power Protection type : Hiccup mode, recovers automatically after fault condition is removed 17.5 ~ 20.25V 22.5 ~ 28V 27.5 ~ 32.4V 13.7 ~ 16.2V Protection type : Shut down o/p voltage, re-power on to recover 90 15 53.3 ~ 64.8V (RTH2) detect on heatsink of power transistor Protection type : Shut down o/p voltage, re-power on to recover -20 ~ +60 (Refer to output load derating curve) 20 ~ 90% RH non-condensing -20 ~ +85 , 10 ~ 95% RH 0.05%/ (0 ~ 50 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes UL60950-1, CB(IEC60950-1) approved I/P-O/P:4.25KVDC I/P-FG:1.5KVAC O/P-FG:0.5KVAC I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 EMI CONDUCTION & RADIATION Compliance to EN55022 (CISPR22) Class B HARMONIC CURRENT Compliance to EN61000-3-2,-3 / 70% RH EMS IMMUNITY Compliance to EN61000-4-2,3,4,5,6,8,11; ENV50204, light industry level, criteria A MTBF 149.3Khrs min. MIL-HDBK-217F (25 169*60.7*28.5mm (L*W*H) 0.32Kg; 48pcs/15.8Kg/0.79CUFT DIMENSION 89% 1A/230VAC ISOLATION RESISTANCE PACKING NOTE 11 ~ 13.2V ASP-150-48 ) 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. File Name:ASP-150-SPEC 2008-09-22 ASP-150 150W Single Output with PFC Function Mechanical Specification series Unit:mm 169 160.5 5 3.5 LED 5 4 3 2 1 50.7 60.7 CN1 6 5 4 3 2 1 FS1 CN2 3.3 28.5 max. 4- AC Input Connector (CN1) : JST B5P-VH or equivalent Pin No. 1 2,4 3 5 Assignment AC/L No Pin AC/N FG Mating Housing Terminal JST VHR or equivalent JST SVH-21T-P1.1 or equivalent DC Output Connector (CN2) : JST B6P-VH or equivalent Pin No. 1,2,3 4,5,6 Assignment -V +V Terminal JST SVH-21T-P1.1 or equivalent Mating Housing JST VHR or equivalent Block Diagram EMI FILTER & RECTIFIERS I/P RECTIFIERS & FILTER POWER SWITCHING PFC CIRCUIT FG O.L.P. PFC CONTROL +V -V DETECTION CIRCUIT PWM CONTROL O.V.P. Derating Curve Output Derating VS Input Voltage Ta=25 100 100 90 80 80 70 LOAD (%) LOAD (%) 60 40 20 -20 0 10 20 30 40 50 AMBIENT TEMPERATURE ( ) 60 70 (HORIZONTAL) 60 50 40 90 100 110 135 155 230 264 INPUT VOLTAGE (V) 60Hz File Name:ASP-150-SPEC 2008-09-22