MWP-608 104W Triple Output Switching Power Supply Features : Universal AC input/Full range Protections:Short circuit/Over load Cooling by free air convection 2 years warranty SPECIFICATION MWP-608 MODEL OUTPUT OUTPUT NUMBER CH1 CH2 CH3 DC VOLTAGE 5V 12V 24V RATED CURRENT 10A 2A 1.25A CURRENT RANGE 3 ~ 15A 0.2 ~ 4A 0.2 ~ 4A RATED POWER 104W 120mVp-p 150mVp-p RIPPLE & NOISE (max.) Note.2 50mVp-p VOLTAGE ADJ. RANGE CH1: 4.75 ~ 5.5V VOLTAGE TOLERANCE Note.3 2.0% INPUT 8.0% -5,+10% LINE REGULATION 0.5% 1.0% 1.0% LOAD REGULATION 1.0% 6.0% 6.0% SETUP, RISE, HOLD TIME 200ms, 50ms, 16ms at full load VOLTAGE RANGE 88 ~ 132VAC/176 ~ 264VAC selected by switch FREQUENCY RANGE 47 ~ 63Hz EFFICIENCY (Typ.) 80% AC CURRENT INRUSH CURRENT (max.) 2.8A/115VAC 1.7A/230VAC COLD START 20A/115VAC 40A/230VAC LEAKAGE CURRENT PROTECTION OVER LOAD FUNCTION OPERATING DISPLAY WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS WITHSTAND VOLTAGE <3.5mA / 240VAC 150 ~ 200% rated output power (CH1:19.2 ~ 29.2) Protection type : Fold back current limiting, recovers automatically after fault condition is removed Double color LED correct Range: Green(5~5.4Vref.); Wrong Range: Red -10 ~ +60 20 ~ 90% RH non-condensing -20 ~ +85 0.05%/ , 5 ~ 95% RH (0 ~ 50 ) on +5V output 10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes TUV EN60950-1 Approved I/P-O/P:3KVAC I/P-FG:1.5KVAC I/P-O/P, I/P-FG :100M Ohms/500VDC SAFETY & ISOLATION RESISTANCE EMI CONDUCTION & RADIATION Compliance to EN55022 (CISPR22) Class B EMC (Note 4) Compliance to EN60555-2,-3 HARMONIC CURRENT OTHERS EMS IMMUNITY MTBF DIMENSION PACKING NOTE Compliance to EN61000-4-2,3,4,5 Light industry level, criteria A 267K hrs min. MIL-HDBK-217F (25 ) 180*110*50mm (L*W*H) 203*115*50mm(L*W*H) with terminal & fixed iron 0.9Kg; 16pcs/15.4Kg/0.95CUFT 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Load regulation is measured from 20% to 100% rated load, and other output at 60% rated load. 5. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. File Name:MWP-608-SPEC 2004-12-01