SCN-600 600W Single Output With Parallel Function series Features : AC input range selected by switch Protections: Short circuit / Overload / Over voltage / Over temp. High reliability/ Low ripple noise Built-in remote sense function Built-in remote ON-OFF control Built-in parallel operation function Can adjust from 20~100% output voltage by external control 1-5V Forced air cooling by built-in DC fan Case coating with paint 2 years warranty SPECIFICATION ORDER NO. OUTPUT SCN-600-05 SCN-600-12 SCN-600-15 SCN-600-18 SCN-600-24 SCN-600-48 SAFETY MODEL NO. 600S-N005 600S-N012 600S-N015 600S-N018 600S-N024 600S-N048 DC VOLTAGE 5V 12V 15V 18V 24V 48V RATED CURRENT 100A 50A 40A 33A 25A 12A CURRENT RANGE 0 ~ 100A 0 ~ 50A 0 ~ 40A 0 ~ 33A 0 ~ 25A 0 ~ 12A RATED POWER 500W 600W 600W 594W 600W 576W 120mVp-p 150mVp-p 180mVp-p 240mVp-p 480mVp-p RIPPLE & NOISE (max.) Note.2 100mVp-p VOLTAGE ADJ. RANGE 5.0% typical adjustment by potentiometer 1.0% VOLTAGE TOLERANCE Note.3 1.5% 20~100% adjustment by 1~5VDC external control 1.0% 1.0% 1.0% 1.0% LINE REGULATION 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% LOAD REGULATION 1.0% 0.5% 0.5% 0.5% 0.5% 0.5% SETUP, RISE, HOLD UP TIME 800ms, 50ms, 16ms at full load INPUT VOLTAGE RANGE 90 ~ 130VAC / 180 ~ 260VAC selected by switch, 260 ~ 370VDC FREQUENCY RANGE 47 ~ 63Hz EFFICIENCY (Typ.) 77% 11A / 115VAC AC CURRENT INRUSH CURRENT (max.) 82% 85% 3.5mA / 240VAC OVERLOAD WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT 110 ~ 135% follow to output set up point Protection type : Shut down o/p voltage, re-power on to recover >100 / measure by heat sink, near transformer Protection type : Shut down o/p voltage, re-power on to recover -10 ~ +65 (Refer to output load derating curve) 20% ~ 90% RH non-condensing -20 ~ +85 , 10 ~ 95% RH VIBRATION 0.04% / (0 ~ 50 ) 10 ~ 200Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes SAFETY STANDARDS UL60950-1, CSA22.2, IEC60950 approved WITHSTAND VOLTAGE I/P-O/P, I/P-FG:1500VAC I/P-O/P, I/P-FG, 100M Ohms / 500VDC / 25 ISOLATION RESISTANCE 87% 60A / 230VAC 101 ~ 115% 110 ~ 135% rated output power Protection type : Current limiting, delay shut down o/p voltage, re-power on to recover OVER TEMPERATURE EMC 81% LEAKAGE CURRENT PROTECTION OVER VOLTAGE SAFETY & 80% 7.0A / 230VAC / 70% RH (Note. 4) EMI CONDUCTION & RADIATION Compliance to FCC part 15 class A ---HARMONIC CURRENT EMS IMMUNITY ---- OTHERS MTBF DIMENSION PACKING SPECIAL FUNCTION 120Khrs min. MIL-HDBK-217F (25 ) 291*132*68mm (L*W*H) 2.6kg; 8pcs/ 24kg/ CARTON DC voltage adj., Remote sensing, remote control, parallel operation (refer to terminal instruction manual) NOTE 1.All parameters are specified at 230VAC input, rated load, 25 70% RH ambient. 2.Tolerence: includes set up tolerance, line regulation, load regulation. 3.Ripple & noise are measured at 20MHz by using a 12" twisted pair terminated with a 0.1uf & 47uf capacitor. 4.The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. File Name:SCN-600-SPEC 2008-05-06 SCN-600 600W Single Output With Parallel Function Mechanical Specification series Unit:mm 291 200 50.5 #6-32-4 M3(NUT)x3H-4 AC INPUT 30 VS+ VSVCI VCO GND PAR GND INH N FG 68 L 41 15.5 199.5 V ADJ 15 LED POS+ NEG- 291 32 9.5 M3(NUT)x3H-4 M6.0 7.5 NEG AC INPUT BOTTOM SIDE POS DC OUTPUT Air flow direction 115 9 132 250 Derating Curve External DC Control VS Output Voltage Vout 100 OUTPUT VOLTAGE (%) LOAD (%) 100 50 -10 O.V.P. 0 10 20 30 Ta ( 40 ) 50 60 80 non-linear 60 40 20 V 1 2 3 4 5 EXTERNAL VOLTAGE(Typical) File Name:SCN-600-SPEC 2008-05-06 SCP-600 500~600W Parallel (N+1) With PFC Function series Control terminal instruction manual LOAD VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH USING INTERNAL VOLTAGE CONTROL LOAD LOAD LOAD VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH ON/OFF SWITCH ON/OFF CONTROL BY TRANSISTOR ON/OFF CONTROL BY SWITCH REMOTE SENSING H:ON L:OFF Vout GOOD FAIL : LED OFF : LED ON O.V.P. 120% (Typ.) 120 100 VS+ VSVCI VCO PG PAR GND INH 40V / 0.5A MAX. POWER GOOD SIGNAL VS+ VSVCI VCO PG PAR GND INH OUTPUT VOLTAGE (%) LOAD LOAD DC 1-5V 80 Non-Linear 60 40 20 1 OUTPUT VOLTAGE ADJUST WITH DC 1-5V 2 3 4 5 6 EXTERNAL VOLTAGE (DC) LOAD VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH PARALLEL OPERATION WITH REMOTE SENSING V LOAD VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH PARALLEL OPERATION WITHOUT REMOTE SENSING File Name: SCP-600-SPEC 2008-05-06