PSP-1500 1500W Single Output with PFC Function series Features : AC input active surge current limiting Built-in active PFC function Protections: Short circuit / Overload / Over voltage / Over temperature Built-in constant current limiting circuit Built-in remote ON-OFF control Built-in remote sense function 3 years warranty SPECIFICATION MODEL PSP-1500-5 PSP-1500-12 PSP-1500-13.5 PSP-1500-15 PSP-1500-24 PSP-1500-27 DC VOLTAGE 5V 12V 13.5V 15V 24V 27V 48V RATED CURRENT 217.5A 112.5A 100.5A 90A 56.4A 50.4A 28.5A CURRENT RANGE 0 ~ 217.5A 0 ~ 112.5A 0 ~ 100.5A 0 ~ 90A 0 ~ 56.4A 0 ~ 50.4A 0 ~ 28.5A RATED POWER 1087.5W 1350W 1356.75W 1350W 1353.6W 1360.8W 1368W 1500W 1500W 1500W 1500W 1500W 1500W RIPPLE & NOISE (max.) Note.2 100mVp-p 150mVp-p 150mVp-p 150mVp-p 150mVp-p 150mVp-p 200mVp-p VOLTAGE ADJ. RANGE 10 ~ 13.2V 3.0% 12 ~ 15V 2.0% 13.5 ~ 18V 2.0% 20 ~ 26.4V 1.0% 24 ~ 30V 1.0% 41 ~ 56V 1.0% PEAK LOAD OUTPUT Note.4 1200W VOLTAGE TOLERANCE Note.3 INPUT LINE REGULATION 0.5% 0.3% 0.3% 0.3% 0.2% 0.2% 0.2% LOAD REGULATION 2.0% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% SETUP, RISE TIME 1500ms, 50ms/230VAC at full load HOLD UP TIME (Typ.) 24ms/230VAC at full load VOLTAGE RANGE 176 ~ 264VAC FREQUENCY RANGE 47 ~ 63Hz POWER FACTOR (Typ.) 0.96/230VAC at full load EFFICIENCY (Typ.) 77% AC CURRENT (Typ.) INRUSH CURRENT (Typ.) 8.4A/230VAC 80A/230VAC LEAKAGE CURRENT OVERLOAD PROTECTION OVER VOLTAGE OVER TEMPERATURE FUNCTION REMOTE CONTROL WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS SAFETY & WITHSTAND VOLTAGE ISOLATION RESISTANCE EMC (Note 5) EMC EMISSION EMC IMMUNITY MTBF OTHERS DIMENSION PACKING NOTE 4.75 ~ 5.5V 6.0% PSP-1500-48 248 ~ 370VDC 84% 84% 84% 85% 85% 86% <3.5mA / 240VAC 115 ~ 140% rated output power Protection type : Constant current limiting, recovers automatically after fault condition is removed 5.75 ~ 6.75V 13.8 ~ 16.2V 15.5 ~ 18.2V 18 ~ 21V 27.6 ~ 32.4V 31 ~ 36.5V Protection type : Shut down o/p voltage, re-power on to recover 57.6 ~ 67.2V 95 (TSW1) detect on the heatsink of PFC MOSFET 90 (TSW2) detect the winding of output choke Protection type : Shut down o/p voltage, recovers automatically after temperature goes down RC+/RC-: 0 ~ 0.8V=power on ; 4 ~ 10V=power off sink current <30mA -10 ~ +60 (Refer to "Derating Curve") 20 ~ 90% RH non-condensing -20 ~ +85 , 10 ~ 95% RH 0.03%/ (0 ~ 50 10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes Design refer to UL60950-1, TUV EN60950-1 I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH Compliance to EN55022 (CISPR22) Class B, EN61000-3-2,-3 Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, criteria A 43.4K hrs min. MIL-HDBK-217F (25 278*129*190.5mm (L*W*H) 7.4Kg; 2pcs/15.5Kg/1.28CUFT ) 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. 10% Duty cycle maximum within every 30 seconds(max.). Average output power should not exceed the rated power. 5. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. For guidance on how to perform these EMC tests, please refer to EMI testing of component power supplies. (as available on http://www.meanwell.com) File Name:PSP-1500-SPEC 2011-08-18 PSP-1500 1500W Single Output with PFC Function Mechanical Specification Unit:mm 127 Case No. 925A series 31.75 4-M4 200 52 23 max. 18 max. CONTROL 10 8 32 185 4 6 1 3 5 129 39 6-M6 38 Air flow direction 24.75 240 63.5 63.5 190.5 I/P 127 3 2 1 7 190.5 O/P 6-M3 4 8 3 7 2 6 1 5 2 47.5 113 83 ADJ LED 31.75 4-M4 200 278 52 AC Input Terminal Pin No. Assignment Pin No. 1 2 3 Control Pin No. Assignment : MOLEX 5559-NP uses 5558male crimp terminal DC Output Terminal Pin No. Assignment Assignment AC/L AC/N FG Pin No. 1,3,5 2,4,6 Assignment DC OUTPUT +V DC OUTPUT -V Pin No. Assignment Pin No. P(Current share) 1 5 -S 2 6 G 3 7 RC4 8 Block Diagram Terminal Assignment Mating connector NC MOLEX 5556 NC MOLEX 5557-NR Female crimp Terminal +S receptacle RC+ RCG -S P AC/L AC/N FG RC+ +S NC NC +V PSP-500 PSP-500 PSP-500 -V Derating Curve Output Derating VS Input Voltage 12 ~ 48V 100 100 90 80 80 5V 70 LOAD(%) LOAD (%) 60 40 20 -10 0 10 20 30 40 50 AMBIENT TEMPERATURE ( ) 60 70 (HORIZONTAL) 60 50 40 176 264 INPUT VOLTAGE (V) 60Hz File Name:PSP-1500-SPEC 2011-08-18