TKA30 25W DC-DC Triple Output Converter series Features : 2:1 wide input range 4:1 wide input range(option) 1000VDC I/O isolation Built-in EMI filter Remote ON-OFF control Protections: Short circuit / Overload Cooling by free air convection Six-sided shield metal case Epoxy encapsulated 100% burn-in test Approvals: FCC / CE 2 years warranty SPECIFICATION ORDER NO. TKA30A-B TKA30C-B TKA30A-C TKA30B-C TKA30C-C +5V 12V +5V 15V CURRENT RANGE 350 ~ 3500mA 31 ~ 310mA 350 ~ 3500mA 25 ~ 250mA RATED POWER 25W RIPPLE & NOISE (max.) Note.2 100mVp-p LINE REGULATION Note.3 0.5% OUTPUT LOAD REGULATION INPUT Note.4 +5V: 2.0%, V1: 5.0% VOLTAGE ACCURACY +5V: 2.0%, V1: 5.0% SWITCHING FREQUENCY 100KHz min. VOLTAGE RANGE A: 9 ~ 18VDC EFFICIENCY (Typ.) 80% Full load A: 2.61A B: 1.27A C: 0.64A No load A: 40mA B: 18mA C: 10mA DC CURRENT B: 18~36VDC C: 36~72VDC 82% 82% 80% 82% FILTER Pi network REMOTE CONTROL Power on: R.C ~-Vin > 4.5~5.5VDC or open, Power off: R.C~ -Vin <0.8VDC or short Fuse recommended PROTECTION 82% 110 ~ 250% rated output power Protection type : Hiccup mode, recovers automatically after fault condition is removed All output equipped with short circuit Protection type : Hiccup mode, recovers automatically after fault condition is removed OVERLOAD PROTECTION (Note. 5) TKA30B-B DC VOLTAGE SHORT CIRCUIT WORKING TEMP. -25 ~ +85 WORKING HUMIDITY 20% ~ 90% RH non-condensing (Refer to output load derating curve) ENVIRONMENT STORAGE TEMP., HUMIDITY -40 ~ +105 , 10 ~ 95% RH 0.03% / (0 ~ 50 ) TEMP. COEFFICIENT 10 ~ 500Hz, 2G 10min./1 cycle, period for 60min. each along X, Y, Z axes VIBRATION WITHSTAND VOLTAGE SAFETY & ISOLATION RESISTANCE EMI CONDUCTION & RADIATION EMC EMS IMMUNITY OTHERS I/P-O/P:1KVDC I/P-O/P: 100M Ohms / 500VDC / 25 / 70% RH Compliance to EN55022 Class B, FCC part 15 Class B Compliance to EN61000-4-2,3,4,5,6,8, light industry level, criteria A MTBF DIMENSION 100Khrs min. MIL-HDBK-217F(25 WEIGHT 110g ) 50.8*50.8*21.0mm or 2"*2"*0.82" inch (L*W*H) Derating Curve Pin Configuration Mechanical Specification Unit: mm (inch) 7 BOTTOM VIEW 12.7 ( 0.50 ) 21 ( 0.82 ) 8 SIDE VIEW 4 3 2 1 22.9 ( 0.90 ) 15.24 ( 0.60 ) 2.5( 0.10 ) 5.8 ( 0.23 ) 50.8 ( 2.00 ) 6 + 0.2/-0.1 45.72 ( 1.80 ) 5 1.0 Pin No. Output 1 2 3 4 5 6 7 8 R.C No Pin -Vin +Vin +Vout +5V COM -Vout 100 LOAD (%) 30.48 (1.20) 80 -25 0 50.8 ( 2.00) NOTE 25 71 85 50 Ta ( 100 ) 1.All parameters are specified at normal input, rated load, 25 70% RH Ambient. 2.Ripple & noise are measured at 20MHz by using a 12" twisted pair terminated with a 0.1uf & 47uf capacitor. 3.Line regulation is measured from low line to high line at rated load. 4.Load regulation is measured from 20% to 100% rated load. 5.Please prevent the converter from operating in overload or short circuit condition for more than 30 seconds. File Name:TKA30-SPEC 2008-05-20