INTERCONNECTS 2,54 Grid Solder Cup Headers and Sockets Single and Double Row Number of Pins X 2,54 0,99 DIA. HOLE 1,83 DIA. 0,51 DIA. • Series 380 & 480 use MM #8000 pins. See page 183 for details. • Series 329 & 429 use MM #2954 pin receptacles and accept pin diameters from 0,38 - 0,64. See page 142 for details. 3,23 2,79 Series 329, 380, 429, 480 3,15 • Series 329 & 429 receptacles use Hi-Rel, 4 finger BeCu #30 contacts rated at 3 amps. See page 218 for details. 4,22 2,54 • Solder cups are pre-aligned. RoHS • Insulators are high temp. thermoplastic. Fig. 1 2002/95/EC Ordering Information Number of Pins X 2,54 / 2 0,99 DIA. HOLE Series 380...001 Solder Cup / Solder Tail 3,23 1,83 DIA. Fig. 1 2,79 3,15 0,51 DIA. 380-XX-1_ _-00-001000 Specify # of pins 4,22 01-64 Series 480...001 2,54 480-10-2 _ _-00-001000 Fig. 2 Fig. 2 0,38-0,64 0,25 * 0,46 Specify # of pins Number of Pins X 2,54 2,54 2,54 2,79 Solder Cup / Solder Tail 2,54 3,81 For Electrical, Mechanical & Enviromental Data, See pg. 4 Pin Plating 1,35 DIA. 1,52 2,29 For RoHS compliance select plating code. XX=Plating Code See Below SPECIFY PLATING CODE XX= 7,37 02-64 10 90 40 0,25μm Au 5,08μm Sn/Pb Series 329...540 5,08μm Sn Solder Cup Sockets 0,97 DIA. 2,54 HOLE 329-43-1 _ _-41-540000 Fig. 3 Specify # of pins Fig. 3 01-64 Series 429...540 0,38-0,64 0,25 * 0,46 Number of Pins X 2,54 / 2 5,08 Solder Cup Sockets 429-43-2 _ _-41-540000 Fig. 4 Specify # of pins 2,54 2,79 02-64 3,81 7,37 1,35 DIA. For Electrical, Mechanical & Enviromental Data, See pg. 4 1,52 2,29 0,97 DIA. For RoHS compliance select plating code. 2,54 HOLE 2,54 13 PLATING CODE = Fig. 4 w w w. m i l l - m a x . c o m 93 43 Sleeve (Pin) 5,08µm Sn Contact (Clip) 0,76µm Au 75 516-922-6000