RF SAW Filter Part Number Package Application Last Modified 803-RF421.25M-A 3.8 x 3.8 SMD CDMA450 Mar. 2 2007 . TYPE : 421.25 MHz RF-Rx SAW Filter PART NUMBER : 803-RF421.25M-A . OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Condition Minimum Typical Maximum Units - - 421.25 - MHz 420.0 ~ 422.5 MHz - 3.5 4.8 dB Source Impedance (single ended) - - 50 - ohm Load Impedance (double ended) - - 50 - ohm Operating Temperature - -30 - +80 °C 420 ~ 422.5 MHz - 2.1 2.5 - Center Frequency Insertion Loss VSWR Max Input Power Stopband Attenuation - - - 30 dBm 0.3~400.0 MHz 45.0 50.0 - dB 410.0~412.5 MHz 35.0 50.0 - 485.0~1200.0 MHz 35.0 43.0 - 1200.0~2000.0 MHz 30.0 40.0 - * No Matching Network . PACKAGE DRAWING Pin Layout TESTING INVIRONMENT A Ground B Input C Ground D Ground E Output F Ground FREQUENCY RESPONSE VSWR (S11, S22) SMITH CHART Oscilent Corporation - CALL 949.252.0522 18195 East McDurmott Street . Building D . Irvine . CA 92614 . USA Fax: 949.252.0599 . E-Mail: [email protected] Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 803-RF421.25M-A