Oscilent Corporation RF SAW Filter | 803-RF868.3M-A Page 1 of 2 RF SAW Filter Part Number Package Application Last Modified 803-RF868.3M-A 3.8 x 3.8 SMD Wireless Jan. 01, 2007 . TYPE : 868.3 MHz RF SAW Filter PART NUMBER : 803-RF868.3M-A . OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Condition Minimum Typical Maximum Units - - 868.3 - MHz 868 ~ 868.78 MHz - 2.7 4.2 dB DC Voltage - - - 0 V Input Power - - - 0 dBm Operating Temperature - -45 - +90 °C Storage Temperature - -45 - +90 °C 868 ~ 868.78MHz - 1.0 3.0 dB 867.9 ~ 868.88 MHz - 1.5 6.0 - 1500 - kHz 10 ~ 700 MHz 50 55 - dB 700 ~ 830 MHz 40 45 830 ~ 850 MHz 35 40 850 ~ 865.02 MHz 25 28 871 ~ 874.5 MHz 15 20 874.5 ~ 883 MHz 22 26 Center Frequency Insertion Loss Relative Passband 3dB Bandwidth Relative Attenuation 883 ~ 900 MHz 30 35 - 900 ~ 1000 MHz 40 45 - Source Impedance single ended* - 117//3.7 - ohm//Pf Load Impedance single ended* - 117//3.7 - ohm//pF * With Matching Network ((Ref. Testing Environment Circuit as shown) ** Custom SAW RF Filters available. Contact Oscilent for assistance. PACKAGE DRAWING Pin Layout A Ground B Input C Ground D Ground E Output F Ground Oscilent Corporation RF SAW Filter | 803-RF868.3M-A Page 2 of 2 TEST FIXTURE FREQUENCY RESPONSE Oscilent Corporation - CALL 949.252.0522 18195 East McDurmott Street . Building D . Irvine . CA 92614 . USA Fax: 949.252.0599 . E-Mail: [email protected] Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 803-RF868.3M-A