Oscilent Corporation RF SAW Filter | 802-RF915.0M-C Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 802-RF915.0M-C 3.0 x 3.0 SMD Remote control receivers Jun. 23 2003 . TYPE : 915.0 MHz RF SAW Filter Low Loss (3.0dB max.) PART NUMBER : 802-RF915.0M-C . OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Condition Minimum Typical Maximum Units - - 915.0 - MHz 902.0 ~ 928.0 MHz - 2.5 3.0 dB DC Voltage - - - 5 V Input Power - - - 20 dBm Operating Temperature - -30 - +65 °C Storage Temperature - -40 - +85 °C Center Frequency Insertion Loss Ripple Stopband Attenuation VSWR Teminating Impedance 902.0 ~ 928.0 MHz - 0.7 1.5 dB DC ~ 800 MHz 50.0 60.0 - dB 800.0 ~ 845.0 MHz 50.0 55.0 - 845.0 ~ 880.0 MHz 45.0 50.0 - 950.0 ~ 990.0 MHz 26.0 31.0 - 990.0 ~ 1200.0 MHz 50.0 58.0 - 1200.0 ~ 2000.0 MHz 30.0 38.0 - 902.0 ~ 928.0 MHz - 1.45 2.0 - - - 50 - ohm * Maximum Rating (Ta=25°C) ** Custom SAW RF Filters available. Contact Oscilent for assistance. . Pin Layout Frequency Reponse A Ground B Output C Ground D Ground E Input F Ground Oscilent Corporation RF SAW Filter | 802-RF915.0M-C Page 2 of 3 VSWR (S11, S22) Smith Chart Oscilent Corporation - CALL 949.252.0522 18195 East McDurmott Street . Building D . Irvine . CA 92614 . USA Fax: 949.252.0599 . E-Mail: [email protected] Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator 802-RF915.0M-C Oscilent Corporation RF SAW Filter | 802-RF915.0M-C Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map Page 3 of 3