Oscilent Corporation IF SAW Filter | 813-IF70.0M-T Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 813-IF70.0M-T 13.3 x 6.5 SMD Base Station & Repeater May 02 2003 . TYPE : 70.0 MHz Bandpass Filter 12.2 MHz Bandwidth PART NUMBER : 813-IF70.0M-T .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 69.90 70.0 70.10 MHz Insertion Loss - 24.5 26.0 dB 1dB Bandwidth 11.65 11.86 - MHz 3dB Bandwidth 12.20 12.34 - MHz 40dB Bandwidth - 14.60 14.80 MHz Ultimate Rejection - 40 - dB Passband Ripple - 0.80 1.0 dB Group Delay Variation - 40 150 nsec Absolute Delay - 1.08 - µsec Substrate Material - LN - - Ambient Temperature - 25 - °C Center Frequency * Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE Source/Load Impedance = 50 ohms Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator 813-IF70.0M-T Oscilent Corporation IF SAW Filter | 813-IF70.0M-T Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map Page 2 of 2