Oscilent Corporation IF SAW Filter | 820-IF70.0M-G Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 820-IF70.0M-G 20.2 x 12.6 Thru Hole Base Station & Repeater May 02 2003 . TYPE : 70.0 MHz Bandpass Filter 1.10 MHz Bandwidth PART NUMBER : 820-IF70.0M-G . Horizontal : 0.5 MHz/Div Veritical : 10 dB/Div Horizontal : 0.2 MHz/Div Veritical : 1 dB/Div Veritical : 100 ns/Div . OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 69.97 70.00 70.03 MHz Insertion Loss - 22.0 25.0 dB 1dB Bandwidth 0.95 1.08 - MHz 3dB Bandwidth 1.1 1.27 - MHz 40dB Bandwidth - 2.11 2.3 MHz Passband Ripple - 0.35 0.7 dB Group Delay Variation - 80 150 nsec Center Frequency - 2.54 - µsec Ultimate Rejection 50 55 - dB Substrate Material - Quartz - - Ambient Temperature - 25 - °C Phase Linearity - 3.2 5 degc Absolute Delay * Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE http://www.oscilent.com/spec_pages/if_sawfilter/if_820_if70_0g.htm 12/28/2005 Oscilent Corporation IF SAW Filter | 820-IF70.0M-G Page 2 of 2 L1 = 180nH L2 = 220nH Source/Load Impedance = 50 ohms Part No.: 820-IF70.0M-G Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map http://www.oscilent.com/spec_pages/if_sawfilter/if_820_if70_0g.htm 12/28/2005