14 Pin DIP 5 Tap Low-Profile TTL Compatible Active Delay Lines TAP DELAYS ±5% or ±2 nS† TOTAL DELAYS ±5% or ±2 nS† PART NUMBER 5, 10, 15, 20 6, 12, 18, 24 7, 14, 21, 28 8, 16, 24, 32 9, 18, 27, 36 10, 20, 30, 40 12, 24, 36, 48 15, 30, 45, 60 20, 40, 60, 80 25, 50, 75, 100 30, 60, 90, 120 35, 70, 105, 140 40, 80, 120, 160 45, 90, 135, 180 50, 100, 150, 200 60, 120, 180, 240 70, 140, 210, 280 25 30 35 40 45 50 60 75 100 125 150 175 200 225 250 300 350 EP9300 EP9313 EP9314 EP9315 EP9316 EP9301 EP9311 EP9317 EP9302 EP9319 EP9303 EP9320 EP9304 EP9321 EP9305 EP9306 EP9307 †Whichever is greater. TAP DELAYS ±5% or ±2 nS† 80, 160, 240, 320 84, 168, 252, 336 88, 176, 264, 352 90, 180, 270, 360 94, 188, 282, 376 100, 200, 300, 400 110, 220, 330, 440 120, 240, 360, 480 130, 260, 390, 520 140, 280, 420, 560 150, 300, 450, 600 160, 320, 480, 640 170, 340, 510, 680 180, 360, 540, 720 190, 380, 570, 760 200, 400, 600, 800 VOH VOL VIK IIH High-Level Output Voltage Low-Level Output Voltage Input Clamp Voltage High-Level Input Current IIL IOS Low-Level Input Current Short Circuit Output Current ICCH High-Level Supply Current ICCL Low-Level Supply Current TRO Output Rise Time Fanout High-Level Output Fanout Low-Level Output Supply Voltage High-Level Input Voltage Low-Level Input Voltage Input Clamp Current High-Level Output Current Low-Level Output Current Pulse Width of Total Delay Duty Cycle Operating Free-Air Temperature 2.7 -40 0.5 -1.2 50 1.0 -2 -100 V V V µA mA mA mA 14 Pulse Input Voltage Pulse Width % of Total Delay Pulse Rise Time (0.75 - 2.4 Volts) Pulse Repetition Rate @ Td ≤ 200 nS Pulse Repetition Rate @ Td > 200 nS Supply Voltage 12 4 10 6 8 OUTPUT INPUT 1 75 mA 75 mA 4 nS 5 nS 20 TTL LOAD 10 TTL LOAD 7 GROUND Min Max Unit 4.75 2.0 5.25 V V V mA mA mA % % °C 0.8 -18 -1.0 20 40 -55 40 +125 .200 PCA EP93XX Date Code White Dot Pin#1 .300 .280 Max. .100 .780 Max. Unit 3.2 110 2.0 1.0 100 5.0 Volts % nS MHz KHz Volts .015 Typ. .165 Max. .010 Typ. .100 Min. .020 Typ. .365 Max. QAF-CSO1 Rev. B 8/25/94 DSD93XX Rev. A 2/5/96 Unless Otherwise Noted Dimensions in Inches Tolerances: Fractional = ± 1/32 .XX = ± .030 .XXX = ± .010 VCC Package Dimensions Input Pulse Test Conditions @ 25° C VCC EP9308 EP9318 EP9322 EP9309 EP9323 EP9310 EP9330 EP9324 EP9331 EP9325 EP9329 EP9326 EP9332 EP9327 EP9333 EP9328 Schematic *These two values are inter-dependent. EIN PW TRI PRR 400 420 440 450 470 500 550 600 650 700 750 800 850 900 950 1000 Min Max Unit V CC = min. VIL = max. IOH = max V CC = min. VIH = min. I OL= max V CC = min. II = IIK V CC = max. VIN = 2.7V V CC = max. VIN = 5.25V V CC = max. VIN = 0.5V V CC = max. VOUT = 0. (One output at a time) V CC = max. VIN = OPEN V CC = max. VIN = 0 Td ≤ 500 nS (0.75 to 2.4 Volts) Td > 500 nS V CC = max. VOH = 2.7V V CC = max. VOL = 0.5V Recommended Operating Conditions VCC VIH VIL IIK IOH IOL PW* d* TA PART NUMBER Delay times referenced from input to leading edges at 25°C, 5.0V, with no load. DC Electrical Characteristics Parameter Test Conditions NH NL TOTAL DELAYS ±5% or ±2 nS† ELECTRONICS INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 TEL: (818) 892-0761 FAX: (818) 894-5791