Pomona® Model 4804 & Assembly Instructions SMA Cable Plug, Male, Crimp FEATURES: • Fits cable types 174, 179, 187 • Supplied with center conductor and sleeve MATERIALS: Body and Fitting – Brass per QQ-S-764, Type 303, Cond. A Center Contact – Gold Plated Brass per QQ-B-626, Alloy 360, ½ Hard Dielectric – PTFE Gaskets and Seals: Silicone Rubber Finish: Body and Fitting: Passivated steel Center Contact: Hard gold, per MIL-G-45204, Type II, Class 2 RATINGS: Nominal Impedance: 50 Ohms ORDERING INFORMATION: Model 4804 All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm). All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. Made in USA 6/9/99 SY/EH/LS Sales: 800-490-2361 Fax: 888-403-3360 Technical Assistance: 800-241-2060 S:\Engineering \Release\DataSheets\FlukeDataSheet\d_AI_4804_2_01.doc PomonaACCESS 90104 (800) 444-6785 or (425) 446-6010 More drawings available at www.pomonaelectronics.com Page 1 of 2 Pomona® Model 4804 & Assembly Instructions SMA Cable Plug, Male, Crimp FIGURE #1 A. Slide shrink tubing and crimp sleeve over cable. B. Strip cable as shown. C. Flair braid outward slightly by rotating Dielectric. FIGURE #2 D. Place center contact over center conductor, provide gap as shown and solder. FIGURE #3 E. Place connector body over contact sliding barrel under braid. F. Push sleeve up against the body of the connector and crimp. FIGURE #4 G. Push shrink tubing over crimped sleeve so it touches the connector body and shrink the sleeve using a heat or equivalent. gun All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm). All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. Made in USA 6/9/99 SY/EH/LS Sales: 800-490-2361 Fax: 888-403-3360 Technical Assistance: 800-241-2060 S:\Engineering \Release\DataSheets\FlukeDataSheet\d_AI_4804_2_01.doc PomonaACCESS 90104 (800) 444-6785 or (425) 446-6010 More drawings available at www.pomonaelectronics.com Page 2 of 2