Model 73054 TNC Right-Angle Plug, 50 Ohm, Crimp Type, RG55, 142, 223, 400 Materials Center Conductor, Male: Brass, Gold Plated Connector Body: Brass, Nickel Plated Crimp Ferrule: Copper, Nickel Plated Insulators: PTFE Gasket: Silicone Rubber Specifications Model 73054 TNC Right-Angle Plug, 50 Ohm, Crimp Type, RG55, 142, 223, 400 Features • • • • DC – 6GHz bandwidth. Connectors are precision machined. Meets interface requirements MIL-C-39012. Connector accepts cable types RG/U: 55, 142, 223, 400 Sales: 800-490-2361 Technical Support: [email protected] Fax: 425-446-5844 Europe: 31-(0) 40 2675 150 International: 425-446-5500 Where to Buy: www.pomonaelectronics.com USA: Impedance: 50Ω Frequency Range: DC – 6GHz Contact Resistance: Center Conductor: ≤1.5 mΩ Outer Conductor: ≤0.2 mΩ Insulation Reistance: ≥ 5000 MΩ Dielectric Withstand Voltage: 1500V For CE compliance, do not hold in hand when voltages exceed 33 Vrms / 70 Vdc. VSWR: ≤1.5 Number of Insertions: 500 cycles minimum Ordering Information Model: 73054 All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm). All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. Copyright © 2009 D2018800 Rev. 001 Page 1 of 2 Model 73054 TNC Right-Angle Plug, 50 Ohm, Crimp Type, RG55, 142, 223, 400 Cable Types and Crimp Die Information Connector Model # 73054 Cable Groups RG55, 142, 223, 400 Crimp Die Cavity Size for Outer Ferrule .230 (5.9) Cable Assembly Instructions Sales: 800-490-2361 Technical Support: [email protected] Fax: 425-446-5844 Europe: 31-(0) 40 2675 150 International: 425-446-5500 Where to Buy: www.pomonaelectronics.com USA: All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm). All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. Copyright © 2009 D2018800 Rev. 001 Page 2 of 2