RECTRON 3KP22AS SEMICONDUCTOR TECHNICAL SPECIFICATION GPP TRANSIENT VOLTAGE SUPPRESSOR 3000 WATT PEAK POWER 8.0 WATTS STEADY STATE FEATURES Plastic package has underwriters laboratory Glass passivated chip construction 3000 watt surage capability at 1ms Excellent clamping capability Low zener impedance Fast response time D2PAK MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS o Ratings at 25 C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load, .126 (3.20) .110 (2.80) Ratings at 25 o C ambient temperature unless otherwise specified. .202 (5.13) .198 (5.03) .412 (10.46) .388 (9.86) For capacitive load, derate current by 20%. .055 (1.40) .047 (1.20) .036 (0.91) .028 (0.71) .098 (2.50) .083 (2.10) 2 .069 (1.75) K .053 (1.35) 1 .189 (4.80) .173 (4.40) .053 (1.35) .049 (1.25) .626 (15.89) .578 (14.69) .337 (8.55) .321 (8.15) .049 (1.25 REF.) * * * * * * PIN 1 PIN 2 K - HEATSINK .020 (0.50) .012 (0.30) Dimensions in inches and (millimeters) MAXIMUM RATINGS (At T A = 25oC unless otherwise noted) SYMBOL VALUE UNITS Peak Pulse Power Dissipation with a 10/1000uS waveform (Note 1, FIG.1) P PPM Minimum 3000 Watts Peak Pulse Current with a 10/1000uS waveform (Note 1, Fig. 3) I PPM SEE TABLE 1 Amps PM(AV) 8.0 Watts I FSM 250 Amps T J , T STG -55 to + 150 RATINGS Steady State Power Dissipation at TL = 75 oC lead lengths 0.375” (9.5mm) (Note 2) Peak Forward Surge Current, 8.3ms single half sine wavesuperimposed on rated load( JEDEC METHOD ) (Note 3) Operating and Storage Temperature Range NOTES : 1. Non-repetitive current pulse, per Fig.3 and derated above TA = 25o C per Fig.2. 2. Mounted on copper pad area of 0.8 X 0.8” ( 20 X 20mm ) per Fig. 5 3. Measured on 8.3mS single half sine-wave or equivalent square wave, duty cycle = 4 pulses per minute maximum. 0 C 2004-6 REV: O Non-Repetitive Pulse Waveform Shown in Fig.3 TA = 25 10 1.0 0.1 0.1uS 1.0uS 10uS 100uS 1.0mS 10mS FIG. 2 - PULSE DERATING CURVE (IPP) DERATING IN PERCENTAGE,% PPPM, PEAK PULSE POWER, kW FIG. 1 - PEAK PULSE POWER RATING CURVE 100 PEAK PULSE POWER (PPP) OR CURRENT RATING AND CHARACTERISTIC CURVES ( 3KP22AS ) 100 75 50 25 0 0 25 TP, PULSE WIDTH, sec 100 125 150 175 200 ) 100000 tr = 10usec. f = 1.0 MHz Vsig = 50mVp-p TJ = 25 Pulse Width (td) is Defined as the Point Where the Peak Current Decays to 50% of IPPM Peak Value IPPM CJ, CAPACITANCE, pF IPPM, PEAK PULSE CURRENT,% 75 FIG. 4 - TYPICAL JUNCTION CAPACITANCE FIG. 3 - PULSE WAVEFORM 150 100 IPPM HALF VALUE 2 10/1000usec. Waveform as Defined by R.E.A. 50 Measured at Stand off Voltage,VWM 1000 td 0 100 1.0 2.0 t, TIME,mS 3.0 4.0 1.0 Lead Lengths 60Hz Resistive or Inductive Load 6 4 0.8X0.8X0.040" (20X20mm) Copper Heat Sinks 0 IFSM, PEAK FORWARD SURGE CURRENT AMPERES L = 0.375"(9.5mm) 10 100 200 V(BR), BREAKDOWN VOLTACE, VOLTS FIG. 6 - MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT UNIDIRECTIONAL FIG. 5 - STEADY STATE POWER DERATING CURVE 8 2 Measured at Zero Bias 10000 0 PM(AV), STEADY STATE POWER DISSIATION, WATTS 50 TA, AMBIENT TEMPERATURE,( 300 8.3ms Single Half Sine-Wave (JEDED Method) 250 200 150 100 50 0 0 25 50 75 100 125 150 TL, LEAD TEMPERATURE ( 175 ) 200 1 10 NUMBER OF CYCLES AT 60 Hz RECTRON 100 TRANSIENT VOLTAGE SUPPRESSORS 3000W SERIES TVS DIODES / D2PAK 3000W (TABLE 1) TYPE 3KP22AS Breakdown Voltage VBR @IT (Volts) MIN. MAX. (mA) Reverse Stand off Voltage VWM (Volts) 24.40 26.90 5.0 22 Maximum Reverse Leakage at VWM ID(uA) Maximum Peak Pulse Current IPPM (Amps) Maximum Clamping Voltage at IPPM VC (Volts) 10 84.40 35.50 RECTRON