RFHIC RTP26010-S0

GaN-SiC Pallet Amplifier
RTP26010-S0
Product Features
Application
• Doherty amplifier design
• GaN on SiC HEMT
• Small and light weight
• 50 Ohm Input/Output impedance matched
• Highly reliable and rugged design
• High efficiency, High Gain
• 8W typical PAVG
• WiMAX DPD amplifier
• General purpose RF amplifier
Description
The RTP26010-S0 is designed for RF system application frequencies from 2496MHz to 2690MHz, with high gain.
This Pallet Amplifier uses GaN on SiC HEMT technology which performs high breakdown voltage, high linearity, high
efficiency. The RTP26010-S0 is DPD application amplifier.
Electrical Specifications @ VDD=+30VDC, T=25°C, 50Ω
System
PARAMETER
Symbol
Min
Typ
Max
Unit
Frequency Range
BW
2496
-
2690
MHz
Output Power
PAVG
-
8
10
Watt
Output Power @ Psat G.C.P
Psat
-
50
-
Watt
Small Signal Gain
SSG
45
-
-
dB
Small Signal Gain Flatness
ΔG
-
± 1.0
±2
dB
Gain Variation
ΔGt
± 3.0
dB
ACLR @ WiMAX 10MHz 2FA
ACLR
-25dBr
dBr
Input VSWR
S11
-
1.5:1
1.7:1
-
Forward Coupling
FC
-
-30
-
dB
Operating Voltage
VDC
28
30
-
Volt
Efficiency @ Pout 10Watt
E
30
%
※ Test Signal Condition : WCDMA 4FA
Environmental Characteristics
PARAMETER
Symbol
Min
Typ
Max
Unit
Operating Temperature
Tc
-20
-
+50
°C
Storage Temperature
Ts
-30
-
+60
°C
Mechanical Specifications
PARAMETER
Value
Units
Limits
Dimensions ( L x W x H )
150 x 90 x 18.5
mm
Max
RF Connectors In/Out
SMA Female
RF Connector Coupling
MCX Female
DC Connectors / Controls
Main 4Pin, Sub 6Pin
Cooling
External Heat sink + airflow
▪ Tel : 82-31-250-5011
▪ All specifications may change without notice.
▪ [email protected]
▪ Version 0.3
GaN-SiC Pallet Amplifier
RTP26010-S0
RF Interface Connectors
Pin #
Description
Specifications
1
RF IN
RF Input signal from TRx B’d
2
RF OUT
RF Output signal to TDD switch
3
RF FWD Port
RF Forward Detection signal For Feed-back
Main DC Connector
Pin #
Description
Specifications
1,2
Drive, Main Amp Stage +Vdd
+28V ~ +48V
3,4
GND
Ground
Sub DC Connector
Pin #
Description
Specifications
1, 2
Gain Block Amp Stage +Vgg
+5V
3, 4
GND
Ground
5
TDD Signal
PA TDD control signal for switching gate bias
6
Temp. Monitor
Reporting Temperature data [0.75V/25℃(10mV/℃)]
Outline Drawing
1
▪ Tel : 82-31-250-5011
▪ All specifications may change without notice.
▪ [email protected]
▪ Version 0.3
GaN-SiC Pallet Amplifier
S-Parameter vs. Frequency
RTP26010-S0
WCDMA 4FA Signal @ 2500MHz
WCDMA 4FA Signal @ 2550MHz
WCDMA 4FA Signal @ 2600MHz
WCDMA 4FA Signal @ 2650MHz
WCDMA 4FA Signal @ 2700MHz
RFHIC Corporation (RFHIC) reserves the right to make changes to any products herein or to discontinue any product at any time without notice. RFHIC do not
assume any liability for the suitability of its products for any particular purpose, and disclaims any and all liability, including without limitation consequential or
incidental damages. The product specifications herein expressed have been carefully checked and are assumed to be reliable. However, RFHIC disclaims liability for
inaccuracies and strongly recommends buyers to verify that the information they are using is current before placing purchase orders. RFHIC products are not
intended for use in life support equipment or application where malfunction of the product can be expected to result in personal injury or death. Buyer uses or sells
such products for any such unintended or unauthorized application, buyer shall indemnify, protect and hold RFHIC and its directors, officers, stockholders,
employees, representatives and distributors harmless against any and all claims arising out of such use. RFHIC’s liability under or arising out of damages, claims of
whatsoever kind and nature which RFHIC products could cause shall be limited in amount to the net purchase price of the products sold to buyer by RFHIC.
▪ Tel : 82-31-250-5011
▪ All specifications may change without notice.
▪ [email protected]
▪ Version 0.3