Preliminary RTP26010-N1 GaN-SiC Pallet Amplifier Product Features Application • Doherty amplifier design • GaN on SiC HEMT • Small and light weight • 50 Ohm Input/Output impedance matched • Highly reliable and rugged design • High efficiency • 10W, 12W typical PAVG • WCDMA, LTE DPD amplifier • General purpose RF amplifier Description The RTP26010-N1 is designed for RF system application frequencies from 2570MHz to 2690MHz, with high gain. This Pallet Amplifier uses GaN on SiC HEMT technology which performs high breakdown voltage, high linearity, high efficiency. The RTP26010-N1 is DPD application amplifier. Electrical Specifications @ VDD=+28VDC, T=25°C, 50Ω System PARAMETER Symbol Min Typ Max Unit Frequency Range BW 2570 - 2690 MHz Output Power PAVG - 10 12 Watt Output Power @ Psat G.C.P Psat - 47.5 - Watt Small Signal Gain SSG - 40 - dB Small Signal Gain Flatness ΔG - ± 1.0 ±2 dB Gain Variation ΔGt ± 3.0 - dB ACLR @ WCDMA 20MHz 4FA ACLR -25 -30 - dBr ACLR with DPD ACLR - -50 - dBr Forward Coupling FC - -30 - dB Operating Voltage VDC - 28 - Volt Efficiency @ Pout 10Watt WCDMA E - 38 - % Efficiency @ Pout 12Watt LTE E - 40 - % ※ Test Signal Condition: WCDMA 20MHz 4FA (PAR 7.5dB), LTE 10MHz 1FA (PAR 6.5dB), Test DPD solution : Opticron DPD Environmental Characteristics PARAMETER Symbol Min Typ Max Unit Operating Temperature Tc -30 - +60 °C Storage Temperature Ts -40 - +90 °C Mechanical Specifications PARAMETER Value Units Limits Dimensions ( L x W x H ) 100 x 50 x 20 mm Max Weight 170 g Typical RF Connectors In/Out/Coupling MCX / SMA / MCX Female DC Connectors / Controls 5267-04 Cooling External Heat sink + airflow ▪ Tel : 82-31-250-5078 ▪ All specifications may change without notice. ▪ [email protected] ▪ Version 0.1 Preliminary GaN-SiC Pallet Amplifier RTP26010-N1 RF Interface Connectors Pin # DESCRIPTION Specifications 1 RF IN RF Input signal from TRx B’d 2 RF OUT RF Output signal 3 RF FWD Port RF Forward Detection signal For Feed-back DC Connector Pin # DESCRIPTION Specifications 1 Gain Block Amp +Vgg +5.6Vdc 2 Vdd +28Vdc 3 Vdd +28Vdc 4 GND Ground ※ RF connector and DC connector custom design available. Outline Drawing ▪ Tel : 82-31-250-5078 ▪ All specifications may change without notice. ▪ [email protected] ▪ Version 0.1 Preliminary GaN-SiC Pallet Amplifier RTP26010-N1 Typical Output Spectrum @ WCDMA 20MHz 4FA (PAR 7.5dB) : Pout =10W(40dBm) Frequency 2.58GHz Frequency 2.63GHz Frequency 2.68GHz ▪ Tel : 82-31-250-5078 ▪ All specifications may change without notice. ▪ [email protected] ▪ Version 0.1 Preliminary GaN-SiC Pallet Amplifier RTP26010-N1 Typical Output Spectrum @ LTE 10MHz 1FA (PAR 6.5dB) : Pout =12W(41dBm) Frequency 2.58GHz Frequency 2.63GHz Frequency 2.68GHz RFHIC Corporation (RFHIC) reserves the right to make changes to any products herein or to discontinue any product at any time without notice. RFHIC do not assume any liability for the suitability of its products for any particular purpose, and disclaims any and all liability, including without limitation consequential or incidental damages. The product specifications herein expressed have been carefully checked and are assumed to be reliable. However, RFHIC disclaims liability for inaccuracies and strongly recommends buyers to verify that the information they are using is current before placing purchase orders. RFHIC products are not intended for use in life support equipment or application where malfunction of the product can be expected to result in personal injury or death. Buyer uses or sells such products for any such unintended or unauthorized application, buyer shall indemnify, protect and hold RFHIC and its directors, officers, stockholders, employees, representatives and distributors harmless against any and all claims arising out of such use. RFHIC’s liability under or arising out of damages, claims of whatsoever kind and nature which RFHIC products could cause shall be limited in amount to the net purchase price of the products sold to buyer by RFHIC. ▪ Tel : 82-31-250-5078 ▪ All specifications may change without notice. ▪ [email protected] ▪ Version 0.1