FR601 THRU FR607 FAST RECOVERY RECTIFIERS Voltage – 50 to 1000 Volts Current – 6.0 Ampere Features • Low forward voltage drop • Low leakage • High current capability • High reliability • High current surge • Fast switching Mechanical Data • Case: Molded plastic. • Epoxy: UL 94V-0 rate flame retardant. • Terminals: MIL-STD-202E, method 208C guaranteed. • Polarity: Color band denotes cathode end. • Mounting Position: Any. Absolute Maximum Ratings and Characteristics @ 250C unless otherwise specified. Single phase half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20%. Symbols FR601 FR602 FR603 FR604 FR605 FR606 FR607 Units Maximum repetitive peak reverse voltage VRRM 50 100 200 400 600 800 1000 Volts Maximum RMS voltage VRMS 35 70 140 280 420 560 700 Volts Maximum DC blocking voltage VDC 50 100 200 400 600 800 1000 Volts Maximum Average forward rectified current at TA = 75 OC Peak forward surge current 8.3ms single half sine-wave, superimposed on rated load (JEDEC method) Maximum instantaneous forward voltage at IFM = 6 A , Maximum DC reverse current TA = 25 OC at rated DC blocking voltage TL = 55OC I(AV) 6.0 Amps IFSM 300 Amps VF 1.3 Volts 10 IR Maximum reverse recovery time (Note 1) Trr Typical junction capacitance (Note 2) CJ 150 TJ ,TS -65 to +150 Operating and storage temperature range µA 150 150 250 500 nS pF O 1) Reverse recovery test conditions: IF = 0.5A, IR = 1A, Irr = 0.25A 2) Measured at 1MHZ and applied reverse voltage of 4volts D.C. SEMTECH ELECTRONICS LTD. ® (Subsidiary of Semtech International Holdings Limited, acompany listed on the Hong Kong Stock Exchange, Stock Code: 724) Dated : 12/04/2003 C FR601 THRU FR607 MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT PEAK FORWARD SURGE CURRENT.(A) AVERAGE FORWARD CURRENT.(A) TYPICAL FORWARD CURRENT DERATING CURVE single phase,half wave 60Hz resistive or inductive load 8.3 ms single half sine wave JEDEC method NUMBER OF CYCLES AT 60Hz Ambient Temperature Ta ( ℃ ) TYPICAL JUNCTION CAPACITANCE JUNCTION CAPACITANCE.(pF) INSTANTANEOUS FORWARD CURRENT.(A) TYPICAL FORWARD CHARACTERISTICS Tj=25 C Pulse Width 300us 1% Duty Cycle TJ=25 C FORWARD VOLTAGE .(V) REVERSE VOLTAGE.(V) T E ST C IR C U IT D IA G R A M A N D R E V E R SE R E C O V E R Y T IM E C H A R A C T E R IST IC S 50Ω N O N -IN D U C T IV E 10 Ω N O N -IN D U C TIV E trr +0.5A 0 pulse generator (N ote 2) 25V dc (approx.) Ω noninductive oscilliscope (N ote 1) N otes: 1.R ise tim e = 2ns m ax. Input im pedance= 1m egohm .22pF 2. R ise tim e= 10ns m ax. Source im pedance= 50ohm s. -0.25A -1.0A 1cm set time base for 50/10ns/cm SEMTECH ELECTRONICS LTD. ® (Subsidiary of Semtech International Holdings Limited, acompany listed on the Hong Kong Stock Exchange, Stock Code: 724) Dated : 12/04/2003