OC-3 SFP Transceiver SP-03-MX Features • Data Rate 155.52 Mb/s • Single 3.3V Supply • 2 km Reach for 62.5/125 mm MMF (500 MHz•km) • 1310nm FP Laser • Commercial Temperature Available (-CxA) • Industrial Temperature Available (-TxA) • SFP MSA SFF-8074i Compliant • Compliant with ANSI-T1.105.06 SR-0 • Telcordia GR-468 Compliant • Color coded bail latch tube : Grey • RoHS compliant General Operation Parameter Supply Voltage Total Current Symbol Min. Typical Max. Unit Vcc 3.135 3.3 3.465 V Icc - - 300 mA Power Supply Noise Rejectiona PSR 100 - - mVp-p Operating Temperature (-CxA) Top -5 - 70 ºC Operating Temperature (-TxA) Top -40 - 85 ºC Storage Temperature Tst -40 - 85 ºC Data Rate DR 10 155.52 200 Mbps Symbol Min Typical Max Unit Pop -20 - -14 dBm Average Launch Power (Tx:Off) Poff - - -45 dBm Extinction Ratio ER 10 - - dB a) 20Hz to 155MHz Transmitter Specifications (Optical) Parameter Optical Power Eye Mask SONET/SDH compliant Optical Rise Timeb tr - Optical Fall Timeb tf - Mean Wavelength λ 1270 ∆λ - Spectral Width (RMS) - 2 ns 2 ns - 1380 nm - 7.7 nm b) 20%-80% values LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 1 LUMNDS1511-Mar1908 Rev A.3 OC-3 SFP Transceiver SP-03-MX Transmitter Specifications (Electrical) Parameter Symbol Min Typical Max Unit Rin 80 100 120 Ω PECL Single-Ended Data Input Swing Vin,p-p 250 - 1200 mV TxFault_Fault Vfault 2 - Vcc V Vnormal Vee - Vee+0.5 V Vd 2 - Vcc V Ven Vee - Vee+0.8 V Symbol Min Typical Max Unit Rsens,low - - -30 dBm Receive Power High Rsens,high -8 - - dBm Receiver Damage Power Pin,damage 0 - - dBm λ 1260 1310 1360 nm LOS Assert LOS_A -45 - - dBm LOS De-Assert LOS_D - - -30 dBm LOS Hysteresis Hys 0.5 - - dB Parameter Symbol Min Typical Max Unit PECL Single-Ended Data Output Swing Input Differential Impedence TxFault_Normal TxDisable_Disable TxDisable_Enable Receiver Specifications (Optical) Parameter c Receive Power Low c Wavelengthd c) 223-1 PRBS, BER 10-10 ,155.52 Mbps d) Operational over 1200 to 1625nm range Receiver Specifications (Electrical) Vout, p-p 185 - 800 mV Data Output Rise Time tr - - 2 ns Data Output Fall Time tf - - 2 ns Timing and Electrical Parameter Symbol Min Typical Tx Disable Negate Time t_on - Tx Disable Assert Time t_off - Time To Initialize, Including Reset Of Tx Fault Max Unit - 1 ms - 10 µs t_init - - 300 ms Tx Fault Assert Time t_fault - - 100 µs Tx Disable To Reset t_reset 10 - - µs LOS Assert Time t_loss_on - - 100 µs LOS De-Assert Time t_loss_off - - 100 µs Serial ID Clock Rate f_serial_clock - - 100 KHz RX_LOS Voltage (High) 2 - - V RX_LOS Voltage (Low) - - 0.8 V LOS Output Voltage-Fault VLOS fault 2 - Vcc V VLOSnormal Vee - Vee+0.5 V MOD_DEF (0:2)-High Vh 2 - Vcc V MOD_DEF (0:2)-LOW Vl Vee - Vee+0.5 V LOS Output Voltage-Normal LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 2 LUMNDS1511-Mar1908 Rev A.3 OC-3 SFP Transceiver SP-03-MX Diagnostics Parameter Range Accuracy Unit Calibration Temperature (-CDA) -5 to 70 ±3 ºC External Formula Tc(C) = Tslope*Tad(16 bit signed twos complement value) + Toffset Temperature (-TDA) -40 to 85 ±3 ºC External Tc(C) = Tslope*Tad(16 bit signed twos complement value) + Toffset Voltage 0 to Vcc 0.1 V External V(Volts) = Vslope*Vad (16 bit unsigned integer) + Voffset Bias current 0 to 120 5 mA External I(mA)=Islope*Iad(16 bit unsigned integer)+Ioffset TX Power -20 to -14 ±3dB dBm External TX_PWR(µW)=TX_PWRslope*TX_PWRad(16 bit unsigned integer +TX_PWRoffset RX Power -30 to -8 ±3dB dBm External RX_PWR(µW)=A0+A1*x+A2*x^2+A3*x^3+A4*x^4 EEPROM Serial ID Name of Field Vendor Name Vendor OUI Vendor P/N LUMINENTOIC.COM Description of Field SFP Vendor name(ASCII) IEEE vendor OUI code for LuminentOIC Inc. Part number in ASCII, e.g. SP-03-MX-TDA Address Hex 20 4C L 21 55 U 22 4D M 23 49 I 24 4E N 25 45 E 26 4E N 27 54 T 28 4F O 29 49 I 30 43 C 37 00 38 06 39 B5 40 53 41 50 P 42 30 0 S 43 33 3 44 4D M 45 58 X 46 54 T 47 44 D 48 41 A 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 3 ASCII LUMNDS1511-Mar1908 Rev A.3 OC-3 SFP Transceiver SP-03-MX Pin Function Notes 1 VeeT TX GND 2 TX_FAULT Open Collector 3 TX_DISABLE Internally Pulled High 4 MOD_DEF2 Serial Data Input 5 MOD_DEF1 Serial Clock Input 6 MOD_DEF0 Internally Grounded 7 NC Not Connected 8 LOS Open Collector 9 VeeR RX Ground 10 VeeR RX Ground 11 VeeR RX Ground 12 RXD- RX Data Negative 13 RXD+ RX Data Positive 14 VeeR RX GND 15 VccR RX Power 16 VccT TX Power 17 VeeT TX GND 18 TXD+ TX Data Positive 19 TXD- TX Data Negative 20 VeeT TX GND LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 4 LUMNDS1511-Mar1908 Rev A.3 OC-3 SFP Transceiver SP-03-MX Outline Drawing Units in mm(inches) LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 5 LUMNDS1511-Mar1908 Rev A.3 OC-3 SFP Transceiver SP-03-MX Suggested Transceiver Interface 1�H Vcc 10�F 1�H 0.1�F VCCT .01�F Protocol IC R1 LuminentOIC SFP 10K� TX_DISABLE TX_DISABLE TX_FAULT TX_FAULT TD + SerDes Laser Driver .01�F 100� TD VEET .01�F VCCR 10�F 0.1�F RD + Receiver Amplifier .01�F 100� RD - RX_LOS RX_LOS Vcc R VEER 1 R1 R1 .01�F EEPROM R1 MOD_DEF 2 MOD_DEF 1 MOD_DEF 0 R1=4.7K to 10K� LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 6 LUMNDS1511-Mar1908 Rev A.3 OC-3 SFP Transceiver SP-03-MX Ordering Information Available Options: SP-03-MX-CDA SP-03-MX-TDA SP-03-MX-CNA SP-03-MX-TNA Part Numbering Definitions: SP - 03 - MX - Temperature Diagnostic Revision • SP = Small Form Pluggable 03 = 155 Mbps MX = Multi Mode, 2 Km • Operating Temperature C = Commercial temperature (-5 to 70ºC) T = Industrial temperature (-40 to 85ºC) • Diagnostic D = Digital Diagnostic (SFF-8472) N = No Diagnostic • Design Revision A = RoHS compliant Warnings: Handling Precautions: This device is susceptible to damage as a result of electrostatic discharge (ESD). A static free environment is highly recommended. Follow guidelines according to proper ESD procedures. Laser Safety: Radiation emitted by laser devices can be dangerous to human eyes. Avoid eye exposure to direct or indirect radiation. Legal Notes: IMPORTANT NOTICE! All information contained in this document is subject to change without notice, at LuminentOIC’s sole and absolute discretion. LuminentOIC warrants performance of its products to current specifications only in accordance with the company’s standard one-year warranty; however, specifications designated as “preliminary” are given to describe components only, and LuminentOIC expressly disclaims any and all warranties for said products, including express, implied, and statutory warranties, warranties of merchantability, fitness for a particular purpose, and non-infringement of proprietary rights. Please refer to the company’s Terms and Conditions of Sale for further warranty information. LuminentOIC assumes no liability for applications assistance, customer product design, software performance, or infringement of patents, services, or intellectual property described herein. No license, either express or implied, is granted under any patent right, copyright, or intellectual property right, and LuminentOIC makes no representations or warranties that the product(s) described herein are free from patent, copyright, or intellectual property rights. Products described in this document are NOT intended for use in implantation or other life support applications where malfunction may result in injury or death to persons. LuminentOIC customers using or selling products for use in such applications do so at their own risk and agree to fully defend and indemnify LuminentOIC for any damages resulting from such use or sale. THE INFORMATION CONTAINED IN THIS DOCUMENT IS PROVIDED ON AN “AS IS” BASIS. Customer agrees that LuminentOIC is not liable for any actual, consequential, exemplary, or other damages arising directly or indirectly from any use of the information contained in this document. Customer must contact LuminentOIC to obtain the latest version of this publication to verify, before placing any order, that the information contained herein is current. © LuminentOIC, Inc. 2003 All rights reserved LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 7 LUMNDS1511-Mar1908 Rev A.3