ADNS-5100/ADNS-5100-001 Solid-State Optical Mouse Lens Data Sheet Description Ordering Information The ADNS-5100 and ADNS-5100-001 Solid-State Optical Mouse Lenses are designed for use with the ADNS-5XXX series of Avago Technologies Optical Mouse Sensors. The optical system is completed with the illumination subsystem provided by the ADNS-5200 LED Assembly Clip and the HLMP-ED80-XX000 LED. Together with the LED, the ADNS-5100 and ADNS-5100-001 provides the directed illumination and optical imaging necessary for proper operation of the Optical Mouse Sensor. The lenses are precision molded optical components and should be handled with care to avoid scratching of the optical surfaces. Specify Part Number as follows: Outline Drawings Including Markings and Logos ADNS-5100 Figure 1. ADNS-5100 Solid State Optical Mouse Round Lens outline drawing and detail Flange Part Number Material Round ADNS-5100 Polycarbonate or Polystyrene HH30 Trim ADNS-5100-001 Polycarbonate or Polystyrene HH30 Outline Drawings Including Markings and Logos ADNS-5100-001 Figure 2. ADNS-5100-001 Solid State Optical Mouse Trim Lens outline drawing and detail Mechanical Assemble Requirements All specifications reference Figure 3, Optical System Assembly Diagram Symbol Min. Typical Max. Units Distance from Object Surface to Lens Reference Plane A 2.3 2.4 2.5 mm Distance from Mouse Sensor Lid contact with lens Surface to Object Surface B 7.38 Conditions mm Sensor lid must be in contact with lens housing surface Figure 3. Optical System Assembly Diagram Lens Design Optical Performance Specifications All specifications are based on the Mechanical Assembly Requirements. Numerical Aperture Symbol Min. Typical Max. NA 0.1 0.13 0.16 Units Magnification 1.25 Design Wavelength 639 nm Object to Image Distance 8.83 mm Lens Material*Index of Refraction N Depth of Field DOF Die Coverage Radius 1.580 1.582 Conditions Image at nominal location l = 639nm 1.5840 ±0.5 mm 0.6 mm *Lens material is polycarbonate or polystyrene HH30, therefore, cyanoacrylate based adhesives should not be used as they will cause lens material deformation. Mounting Instructions for the ADNS-5100 Lens to the Base Plate An IGES format drawing file with design specifications for mouse base plate features is available. Note :- Stand-off of the base plate shall not be larger than 5mm as lens surface 7 size is 5.60mm.” Figure 4. Illustration of base plate mounting features These features are useful in maintaining proper positioning and alignment of the ADNS-5100 when used with the Avago Technologies Optical Mouse Sensor. This file can be obtained by contacting your local Avago Technologies sales representative. For product information and a complete list of distributors, please go to our web site: www.avagotech.com Avago, Avago Technologies, and the A logo are trademarks of Avago Technologies, Limited in the United States and other countries. Data subject to change. Copyright © 2007 Avago Technologies Limited. All rights reserved. Obsoletes AV01-0086EN AV02-0115EN - July 31, 2007