SL300 thru SL 1200 FAST RECOVERY, 100ns.HIGH VOLTAGE 40 ma, MINIATURE RECTIFIERS 1 INCH MINIMUM LEADS SMALL SIZE MOLDED PACKAGE PRV 3,000 TO 12,000 VOLTS AVALANCHE CHARACTERISTICS LOW LEAKAGE EDI Type PRV Volts SL300 SL500 SL800 SL1000 SL1200 3,000 5,000 8,000 10,000 12,000 ELECTRICAL CHARACTERISTICS (at TA =25 o C Unless Otherwise Specified) o Average Rectified Forward Current @ 50 C, IO 40 mA Max. Peak Surge Current, IFSM (8.3ms) (Fig.2) 3 Amp 100nanosec Max. Reverse Recovery (Fig.4) t rr 26Volts Max. ForwardVoltageDrop @25 m A, V F o 1 Max. DC Reverse Current @ PRV and 25 C, IR o Max. DC Reverse Current @ PRV and100 C, I R 15 A A o o o o Ambient Operating Temperature Range, TA -55 C to +150 C Storage Temperature Range, TSTG -55 C to +150 C NOTES: 1.It is recommended that a proper heat sink be used on the terminals of this device between the body and soldering point to prevent damage from excess heat. 2.If operated over 10,000v/inch in length, devices should be immersed in oil or re - encapsulated. EDI reserves the right to change these specifications at any time without notice. SL300 thru SL1200 FIG.1 FIG.2 OUTPUT CURRENT vs AMBIENT TEMPERATURE NON- REPETITIVE SURGE CURRENT 0.1SEC % MAXIMUM SURGE % RATED FWD CURRENT 1.0SEC 100 100 75 50 25 75 50 25 0 0 0 25 50 75 100 125 1 150 2 3 O AMBIENT TEMPERATURE ( C) 4 5 6 7 8 9 10 20 30 40 50 60 CYCLES(60 Hz) FIG.3 MECHANICAL LEAD-SOLDER DIPPED COPPER MARKING:CATHODE BAND AND DEVICE TYPE 1.0Min Both Ends .021 Dia. .125 Dia. .400 FIG.4 REVERSE RECOVERY TEST METHOD RECOVERY WAVE FORM RECOVERY WA VE FORM 1000 Trr NI + I F=2MA D.U.T. 0.1 50 NI I RR=1MA PULSE GENERATOR I R=5MA SCOPE WAVE FORMS CIRCUIT ELECTRONIC DEVICES, INC. DESIGNERS AND MANUFACTURERS OF SOLID STATE DEVICES SINCE 1951. 21 GRAY OAKS AVENUE * YONKERS. NEW YORK 10710 914-965-4400 Ee-mail:[email protected] * Wwebsite: http://www.edidiodes.com * FAX 914-965-5531 * 1-800-678-0828