PP 190-193Rotary.qxd 5/8/02 10:40 AM Page 190 SERIES K C SWITCHES ROTARY SWITCHES SPECIFICATIONS Ratings: Electrical Life: Contact Resistance: Dielectric Strength: Insulation Resistance: Operating Force: MATERIALS Housing, Base, Shaft: Contact: Hardware: 350 mA @ 125 VAC 150 mA @ 250 VAC 10,000 cycles typical 25mΩ initial @ 2-4 VDC, 100mA 1,500 max V rms at sea level 100MΩ min. 8.6 N/cm Glass filled nylon Silver plated copper alloy Gold flash over silver plate Nut-Zinc, nickel plated Lockwasher–Steel, zinc plated Stop ring–Brass, nickel plated Series Model No. Actuator Actuator Length KC Bushing Timing Termination Contact Material 01 02 N=Non-Short S=Shorting P=PC Pin L=Solder Lug S F . See Model Options Table A=Flat B=Round D=Slotted 13 B See Actuator Option Chart EXAMPLE KC 7.0 02 N L S GENERAL INFORMATION 26.20 [1.031] 30.0 6.35 [.250] 14.10 [.555] 2.00 [.079] 8.00 [.315] 27.50 [1.083] WITCH E-S 9.50 [.374] SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE. HOW TO ORDER 5.50 [.217] F 1.3 X 3/8-32 UNEF3.05 [.120] 190 Phone: 763-504-3525 Fax: 763-531-8235 6.60 [.260] 2.00 [.079] 18.70 [.736] www.e -switch.com [email protected] PP 190-193Rotary.qxd 5/8/02 10:40 AM Page 191 SERIES K C SWITCHES ROTARY SWITCHES MODEL NUMBER OPTIONS Model 10 11 12 13 14 15 16 17 18 19 50 51 52 53 54 55 56 57 58 59 60 (SP Models) Sw. Func. 12-pos.-No stops ST DT 3 pos. 4 pos. 5 pos. 6 pos. 7 pos. 8 pos. 9 pos. 10 pos. 11 pos. 12 pos. 2 pos. -60° index 2 pos. -90° index 3 pos. -60° index 3 pos. -90° index 4 pos. -60° index 4 pos. -90° index 5 pos. -60° index 6 pos. -60° index Terms A, 1-12 A, 2* A, 1,2* A, 1-3* A, 1-4* A, 1-5* A, 1-6* A, 1-7 A, 1-8 A, 1-9 A, 1-10 A, 1-11 A, 1-12 A, 1,3* A, 1,4* A, 1,3,5* A, 1,4,7 A,1,3,5,7 A,1,4,7,10 A,1,3,5,7,9 A,1,3,5,7,9,11 Model 20 21 22 23 24 25 26 70 71 72 (DP Models) Sw. Func. 6-pos.-No stops ST DT 3 pos. 4 pos. 5 pos. 6 pos. 2 pos. 60° index 2 pos. 90° index 2 pos. 60° index Terms A,C,1-12 A, C,2,8 A,C,1,2,7,8 A,C 1-3, 7-9 A,C,1-4,7-10 A,C,1-5, 7-11 A,C,1-12 A,C,1,3,7,9 A,C,1,4,7,10 A,C,1,3,5,7,9,11 * Note: Switches with P terminations (PC pins) have additional terminal no. 9 as switch support only. This terminal is not connected electrically inside switch. Model 30 31 32 33 34 80 81 (3P Models) Sw. Func. Terms 4-pos.-No stops A,B,C,1-12 ST A,B,C,2,6,10 DT A,B,C,1,2,5,6,9,10 3 pos. A,B,C,1-3,5-7,9-11 4 pos. A,B,C,1-12 2 pos. 60° index A,B,C,1,3,5,7,9,11 2 pos.-90° index A,B,C,1,4,5,8,9,12 Model 40 41 42 43 91 (4P Models) Sw. Func. Terms 3-pos.-No stops all terms ST A,B,C,D,2,5,8,11 DT A,B,C,D,1,2,4,5,7,8,10,11 3 pos. all terms 2 pos. 60° index A,B,C,D,1,3,4,6,7,9,10,12 All models 30° indexing unless otherwise noted. ACTUATOR OPTIONS A B Flat Round D Slotted Available Actuator Lengths (mm) SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE. Actuator A 30.0 38.0 9.5 B 30.0 10.0 7.0 D 0.0 7.0 10.0 13.0 31.5 *All actuators shown in Pos. 1, fully CCW. BUSHING OPTIONS 01 Std. Phone: 763-504-3525 PANEL MOUNTING Fax: 763-531-8235 02 Metric www.e -switch.com PANEL MOUNTING [email protected] 191 PP 190-193Rotary.qxd 5/8/02 10:40 AM Page 192 SERIES K C SWITCHES ROTARY SWITCHES SCHEMATICS & P.C. MOUNTING 3P Model Model 22.20 [.795] 22.20 [.795] 7 6 B A 10 A 3 C 10 45° 11 2 11 2 12 1 1 15° 12 15° 1 POLE 12 POSITIONS DP 9 4 45° 7.70 [.303] 8 5 9 4 3 7 6 7.70 [.303] 8 5 4 POLE 3 POSITIONS 4P Model Model 22.20 [.795] 22.20 [.795] 6 7 C 4 6 7 B C 4 10 3 45° A D 7.70 [.303] 8 5 9 A 3 7.70 [.303] 8 5 9 10 45° 11 2 1 11 2 12 1 15° SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE. SP 12 15° 2 POLE 6 POSITIONS 4 POLE 3 POSITIONS TIMING OPTIONS N S = (STD.) Non-shorting – break before make = Shorting – make before break Note: (S) shorting contacts available only with 30° indexing TERMINATION OPTIONS P P.C. Pin L Solder Lug CONTACT MATERIAL OPTIONS S = Standard Silver over copper alloy 192 Phone: 763-504-3525 Fax: 763-531-8235 F = Gold Flash over silver plate over copper alloy www.e -switch.com [email protected]