3.0x2.0mm SURFACE MOUNT LED LAMP AA3020SECK Features SUPER BRIGHT ORANGE Description 3.0MM X 2.0MM, 1.4MM HIGH, ONLY MINIMUM The Super Bright Orange source color devices are made SPACE REQUIRED. with DH InGaAlP on GaAs substrate Light Emitting Diode. SUITABLE FOR COMPACT OPTOELECTRONIC APPLICATIONS. LOW POWER CONSUMPTION. PACKAGE : 2000PCS / REEL. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3.Specifications are subject to change without notice. SPEC NO: DSAD1216 REV NO: V.2 DATE: MAR/05/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG PAGE: 1 OF 4 ERP:1201000132 Selection Guide Part No. Dice SUPER BRIGHT ORANGE (InGaAlP) AA3020SECK Iv (mcd) @ 20mA Lens Type Viewing Angle Min. Typ. 2θ θ1/2 70 150 90° WATER CLEAR Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength Super Bright Orange λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 610 nm IF=20mA Super Bright Orange 601 nm IF=20mA Spectral Line Half-width Super Bright Orange 29 nm IF=20mA C Capacitance Super Bright Orange 15 pF VF=0V;f=1MHz VF Forward Voltage Super Bright Orange 2.1 2.5 V IF=20mA IR Reverse Current Super Bright Orange 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Super Bright Orange Units Power dissipation 75 mW DC Forward Current 30 mA Peak Forward Current [1] 195 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD1216 REV NO: V.2 DATE: MAR/05/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG PAGE: 2 OF 4 ERP:1201000132 Super Bright Orange AA3020SECK SPEC NO: DSAD1216 REV NO: V.2 DATE: MAR/05/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG PAGE: 3 OF 4 ERP:1201000132 AA3020SECK Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength), the condition as follows: 1.Wavelength: +/-1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/-15% (Test condition is based on the sorting standard). 3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard). SPEC NO: DSAD1216 REV NO: V.2 DATE: MAR/05/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG PAGE: 4 OF 4 ERP:1201000132