3.0x2.0mm SURFACE MOUNT LED LAMP AA3020SURC Features HYPER RED Description 3.0MM X 2.0MM, 1.4MM HIGH, ONLY MINIMUM The Hyper Red source color devices are made SPACE REQUIRED. with DH InGaAlP on GaAs substrate Light Emitting Diode. SUITABLE FOR COMPACT OPTOELECTRONIC APPLICATIONS. LOW POWER CONSUMPTION. PACKAGE : 2000PCS / REEL. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3.Specifications are subject to change without notice. SPEC NO: DSAD1213 REV NO: V.3 DATE: MAR/05/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG PAGE: 1 OF 4 ERP:1201000144 Selection Guide Part No. Dice HYPER RED (InGaAlP) AA3020SURC Iv (mcd) @ 20mA Lens Type WATER CLEAR Viewing Angle Min. Typ. 2θ θ1/2 110 230 90° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Hyper Red λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 640 nm IF=20mA Hyper Red 628 nm IF=20mA Spectral Line Half-width Hyper Red 27 nm IF=20mA C Capacitance Hyper Red 45 pF VF=0V;f=1MHz VF Forward Voltage Hyper Red 1.9 2.5 V IF=20mA IR Reverse Current Hyper Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Hyper Red Units Power dissipation 170 mW DC Forward Current 30 mA Peak Forward Current [1] 185 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD1213 REV NO: V.3 DATE: MAR/05/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG PAGE: 2 OF 4 ERP:1201000144 Hyper Red AA3020SURC SPEC NO: DSAD1213 REV NO: V.3 DATE: MAR/05/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG PAGE: 3 OF 4 ERP:1201000144 AA3020SURC Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength), the condition as follows: 1.Wavelength: +/-1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/-15% (Test condition is based on the sorting standard). 3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard). SPEC NO: DSAD1213 REV NO: V.3 DATE: MAR/05/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG PAGE: 4 OF 4 ERP:1201000144