SUBMINIATURE SOLID STATE LAMP AM2520SURC09 HYPER RED Features Description OWIDE VIEWING ANGLE. The Hyper Red source color devices are made OSUBMINIATURE PACKAGE. with DH InGaAlP on GaAs substrate Light Emitting Diode. OZ-BEND LEAD. OLONG LIFE - SOLID STATE RELIABILITY. OLOW PACKAGE PROFILE. OPACKAGE : 1000PCS / REEL. ORoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAD1282 REV NO: V.3 DATE: APR/06/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1202000699 Selection Guide Part No. Dice AM2520SURC09 Iv (mcd) @ 20mA Lens Type HYPER RED (InGaAlP) WATER CLEAR Viewing Angle Min. Typ. 2θ1/2 280 1000 20° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Hyper Red λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 640 nm IF=20mA Hyper Red 628 nm IF=20mA Spectral Line Half-width Hyper Red 27 nm IF=20mA C Capacitance Hyper Red 45 pF VF=0V;f=1MHz VF Forward Voltage Hyper Red 1.9 2.5 V IF=20mA IR Reverse Current Hyper Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Hyper Red Units Power dissipation 170 mW Forward Current 30 mA Peak Forward Current [1] 185 mA 5 V Reverse Voltage -40°C To +85°C Operating / Storage Temperature Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD1282 REV NO: V.3 DATE: APR/06/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1202000699 Hyper Red AM2520SURC09 SPEC NO: DSAD1282 REV NO: V.3 DATE: APR/06/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1202000699 AM2520SURC09 Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAD1282 REV NO: V.3 DATE: APR/06/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1202000699