3.5 x2.8mm SMD CHIP LED LAMP APED3528SURC-F01 Features HYPER RED Description SINGLE COLOR. The Hyper Red source color devices are made SUITABLE FOR ALL SMT ASSEMBLY AND SOLDER with DH InGaAlP on GaAs substrate Light Emitting PROCESS. Diode. IDEAL FOR BACKLIGHTING. AVAILABLE ON TAPE AND REEL. PACKAGE: 500PCS / REEL. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.2(0.008") unless otherwise noted. 3. Specifications are subject to change without notice. SPEC NO: DSAF1356 REV NO: V.1 DATE: MAR/28/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.CHENG ERP: 1203001142-01 Selection Guide Part No. Dice APED3528SURC-F01 Iv (mcd) @ 20mA Lens Type HYPER RED (InGaAlP) WATER CLEAR Viewing Angle Min. Typ. 2θ θ1/2 110 500 40° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Hyper Red λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 640 nm IF=20mA Hyper Red 628 nm IF=20mA Spectral Line Half-width Hyper Red 27 nm IF=20mA C Capacitance Hyper Red 45 pF VF=0V;f=1MHz VF Forward Voltage Hyper Red 1.9 2.5 V IF=20mA IR Reverse Current Hyper Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Hyper Red Units Power dissipation 170 mW DC Forward Current 30 mA Peak Forward Current [1] 185 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAF1356 REV NO: V.1 DATE: MAR/28/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.CHENG ERP: 1203001142-01 Hyper Red APED3528SURC-F01 SPEC NO: DSAF1356 REV NO: V.1 DATE: MAR/28/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.CHENG ERP: 1203001142-01 APED3528SURC-F01 Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF1356 REV NO: V.1 DATE: MAR/28/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.CHENG ERP: 1203001142-01