3.2x1.6mm SMD CHIP LED LAMP APTD3216SURC Description Features z3.2mmx1.6mm zLOW zWIDE The Hyper Red source color devices are made with DH InGaAlP on GaAs substrate Light Emitting Diode. VIEWING ANGLE. FOR BACKLIGHT AND INDICATOR. zPACKAGE zRoHS SMT LED,1.8mm THICKNESS. POWER CONSUMPTION. zIDEAL HYPER RED : 2000PCS / REEL. COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.2(0.008") unless otherwise noted. 3. Specifications are subject to change without notice. SPEC NO: DSAB9994 REV NO: V.6 DATE: MAR/16/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP: 1203002299 Selection Guide Part No. Dice APTD3216SURC Iv (mcd) @ 20mA Lens Type HYPER RED (InGaAlP) Viewing Angle Min. Typ. 2 θ 1/2 280 600 50° WATER CLEAR Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Hyper Red λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 640 nm IF=20mA Hyper Red 628 nm IF=20mA Spectral Line Half-width Hyper Red 27 nm IF=20mA C Capacitance Hyper Red 45 pF VF=0V;f=1MHz VF Forward Voltage Hyper Red 1.9 2.5 V IF=20mA IR Reverse Current Hyper Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Hyper Red Units Power dissipation 170 mW DC Forward Current 30 mA Peak Forward Current [1] 185 mA 5 V Reverse Voltage Operating / Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAB9994 REV NO: V.6 DATE: MAR/16/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP: 1203002299 Hyper Red APTD3216SURC SPEC NO: DSAB9994 REV NO: V.6 DATE: MAR/16/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP: 1203002299 APTD3216SURC Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAB9994 REV NO: V.6 DATE: MAR/16/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP: 1203002299