T-1 3/4 (5mm) SOLID STATE LAMP WP7113SGC Features SUPER BRIGHT GREEN Description LOW POWER CONSUMPTION. POPULAR T-1 3/4 DIAMETER PACKAGE. The Super Bright Green source color devices are made with Gallium Phosphide Green Light Emitting Diode. GENERAL PURPOSE LEADS. RELIABLE AND RUGGED. LONG LIFE - SOLID STATE RELIABILITY. AVAILABLE ON TAPE AND REEL. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAF2426 REV NO: V.1 DATE: APR/28/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: H.Q.YUAN ERP:1101005226 Selection Guide Part No. Dice WP7113SGC Iv (mcd) @ 20mA Lens Type SUPER BRIGHT GREEN (GaP) WATER CLEAR Viewing Angle Min. Typ. 2θ θ1/2 70 200 20° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Super Bright Green λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 565 nm IF=20mA Super Bright Green 568 nm IF=20mA Spectral Line Half-width Super Bright Green 30 nm IF=20mA C Capacitance Super Bright Green 15 pF VF=0V;f=1MHz VF Forward Voltage Super Bright Green 2.2 2.5 V IF=20mA IR Reverse Current Super Bright Green 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Super Bright Green Units Power dissipation 105 mW DC Forward Current 25 mA Peak Forward Current [1] 140 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 3 Seconds Lead Solder Temperature [3] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAF2426 REV NO: V.1 DATE: APR/28/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: H.Q.YUAN ERP:1101005226 Super Bright Green WP7113SGC Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF2426 REV NO: V.1 DATE: APR/28/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: H.Q.YUAN ERP:1101005226 PACKING & LABEL SPECIFICATIONS WP7113SGC SPEC NO: DSAF2426 REV NO: V.1 DATE: APR/28/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: H.Q.YUAN ERP:1101005226