T-1 (3mm) SOLID STATE LAMP WP34HD BRIGHT RED Description Features The Bright Red source color devices are m ade LOW POWER CONSUMPTION. POPULAR T-1 DIAMETER PACKAGE. with Gallium Phosphide Red Light Emitting Diode. GENERAL PURPOSE LEADS. RELIABLE AND RUGGED. LONG LIFE - SOLID STATE RELIABILITY. AVAILABLE ON TAPE AND REEL. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAF0514 REV NO: V.2 DATE: APR/16/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1101003433 Selection Guide Part No. Dice WP34HD Iv (mcd) @ 10mA Lens Type BRIGHT RED (GaP) Viewing Angle Min. Typ. 2 θ 1/2 1 3 60° RED DIFFUSED Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Bright Red λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 700 nm IF=20mA Bright Red 660 nm IF=20mA Spectral Line Half-width Bright Red 45 nm IF=20mA C Capacitance Bright Red 40 pF VF=0V;f=1MHz VF Forward Voltage Bright Red 2.25 2.5 V IF=20mA IR Reverse Current Bright Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Bright Red Units Power dissipation 120 mW DC Forward Current 25 mA Peak Forward Current [1] 130 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 3 Seconds Lead Solder Temperature [3] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAF0514 REV NO: V.2 DATE: APR/16/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1101003433 Bright Red WP34HD SPEC NO: DSAF0514 REV NO: V.2 DATE: APR/16/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1101003433 PACKING & LABEL SPECIFICATIONS WP34HD Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF0514 REV NO: V.2 DATE: APR/16/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1101003433