4 FO-55112-C 3 2 1 HONEYWELL PART NUMBER REV DOCUMENT E 0068435 CHANGED BY MH 19AUG10 CHECK RS SS361RT NOTES 1 - SOLDERING INSTRUCTIONS: EXPOSURE TO HIGH TEMPERATURES SHOULD BE KEPT AT A MINIMUM HONEYWELL RECOMMENDS AN INFRARED REFLOW PROCESS WITH PEAK TEMPERATURES NOT EXCEEDING 245 C $ FOR 10 SECONDS MAXIMUM. DO NOT WAVE SOLDER THIS PRODUCT, AS THIS PROCESS MAY NEGATIVELY AFFECT THE SENSOR'S PERFORMANCE AND RELIABILITY. SUBJECTING THESE PRODUCTS TO WAVE SOLDERING WILL VOID HONEYWELL'S WARRANTY 2 ABSOLUTE MAXIMUM RATINGS ARE THE EXTREME LIMITS THE DEVICE WILL MOMENTARILY WITHSTAND WITHOUT DAMAGE TO THE DEVICE. ELECTRICAL AND MAGNETIC CHARACTERISTICS ARE NOT GUARANTEED IF THE SPECIFIED VOLTAGE AND/OR CURRENTS ARE EXCEEDED NOR WILL THE DEVICE NECESSARILY OPERATE AT ABSOLUTE MAXIMUM RATING 3 THE MAGNETIC FLUX USED TO OPERATE THE SWITCH MUST BE IN THE DIRECTION AND LOCATION SHOWN. (THIS ASSUMES THE CONVENTION THAT THE DIRECTION OF THE EXTERNAL FLUX OF A MAGNET IS FROM THE NORTH TO THE SOUTH POLE OF THE MAGNET) 4 THE MAGNETIC FIELD STRENGTH (GAUSS) REQUIRED TO CAUSE THE SWITCH TO CHANGE STATE (OPERATE AND RELEASE) WILL BE AS SPECIFIED IN THE MAGNETIC CHARACTERISTICS. TO TEST THE SWITCH AGAINST THE SPECIFIED MAGNETIC CARACTERISTICS, THE SWITCH MUST BE PLACED IN A UNIFORM MAGNETIC FIELD 5 THIS PRODUCT WILL BE SUPPLIED IN TAPE AND REEL FORM PER EIA STD 481. 6 GATE VESAGE PERMITTED IN THESE AREAS. UNDERFLUSH BREAKOUT LIMITED TO .007 7 THESE HALL EFFECT SENSORS MAY HAVE AN INITIAL OUTPUT IN EITHER THE ON OR OFF STATE IF POWERED UP WITH AN APPLIED MAGNETIC FIELD IN THE DIFFERENTIAL ZONE (APPLIED MAGNETIC FIELD > Brp AND < Bop). HONEYWELL RECOMMENDS THAT THE APPLICATION CIRCUIT DESIGNER ALLOW 10 MICROSECONDS AFTER SUPPLY VOLTAGE HAS REACHED 5 VOLTS FOR THE OUTPUT VOLTAGE TO STABILIZE 2.90 D 0.15 C A B HONEYWELL LOGO A 3 GROUND (-) 2.80 CATALOG LISTING 1.60 DATE CODE 1 VCC (+) 0.20 C D NOMINAL PACKAGE HALL ELEMENT C 2 OUTPUT B 3X 0.50 0.30 0.10 C A B D 0.95 D C 1.90 S N 3 SEE DETAIL A (0.77) NOMINAL TO HALL EFFECT SENSING SURFACE 6 B 6 1.45 MAX 1.20 0.413 B 0.787 +0.10 -0.30 +0.050 -0.150 4 $#4 $ 0.10 C SEATING PLANE 0.150 0.000 +0.050 -0.150 C SEATING PLANE C C (0.60 ) 8X 10 $#5 $ A DETAIL SCALE 40:1 A DESIGN UNITS: MM TOLERANCES UNLESS NOTED: DRAWN JLH 29 JAN 09 CHECK JLH 29 JAN 09 THIS DRAWING COVERS A PROPRIETARY ITEM AND IS THE PROPERTY OF HONEYWELL. THIS DRAWING IS NOT TO BE COPIED OR USED WITHOUT THE PERMISSION OF HONEYWELL. INTERPRET PER ASME Y14.5M-1994 OTHER HONEYWELL ENGINEERING STANDARDS MAY APPLY C 4 3 Pro/ENGINEER 2 A TITLE SOLID STATE SENSOR, IC REV SIZE TYPE CAGE_CODE DRAWING NAME C 3D SCALE I - SS361RT NONE SHEET 1 E 1 OF 3 4 FO-55112-C 3 2 1 4.00 #0.10 4.00 #0.10 +0.1 1.5 0 2.00 #0.05 D B 1.75 #0.10 D 0.20 #0.03 R 0.3 MAX 3.50 #0.05 8.0 3.20 #.10 1.40 #0.10 B 3.15 #.10 SECTION B-B +0.3 -0.1 1.00 MIN R0.3 TYP TOP COVER TAPE (0.061) C C TAPE AND REEL DIMENSIONS 5 4.00 #0.25 (TAPE START SLOT) B TAPE SLOT DEPTH GREATER THAN 10mm 10.9 7.9 (MEASURED AT OUTER EDGE) ACCESS HOLE GREATER THAN 40 mm AT SLOT LOCATION B 14.4 MAX (MEASURED AT HUB) 60.0 #1.0 (HUB) 2.0 MIN (DRIVE SPOKES) A 178 MAX 13.0 #0.2 (ARBOR HOLE) A +1.5 8.4 0 (MEASURED AT HUB) 20.2 MIN C THIS DRAWING COVERS A PROPRIETARY ITEM AND IS THE PROPERTY OF HONEYWELL. THIS DRAWING IS NOT TO BE COPIED OR USED WITHOUT THE PERMISSION OF HONEYWELL. DIRECTION OF FEED FROM REEL C SCALE 4 3 2 REV SIZE TYPE CAGE_CODE DRAWING NAME I - SS361RT NONE SHEET 1 E 2 OF 3 4 FO-55112-C 3 2 CHARACTERISTICS ARE AT Vs=3.0 TO 24.0 VOLTS WITH 20 mA LOAD WITH TA=-40 C $ TO +150 C $ UNLESS OTHERWISE NOTED 4 1 7 RATED SUPPLY VOLTAGE PARAMETER SUPPLY VOLTAGE SUPPLY CURRENT CONDITIONS MIN TYP MAX -40 $C TO 125 $C 3.0 24.0 150 $C 3.0 12.0 VSUPPLY=5V AT 25 $C 4.0 6.0 VSUPPLY=3V AT 25 $C 3.5 5.0 UNITS VOLTS 15 mA 8.0 OUTPUT CURRENT C 20.0 mA Vsat GAUSS > 120 0.4 VOLTS OUTPUT LEAKAGE GAUSS < -120 10.0 µA RISE TIME 25 $C 1.5 µS FALL TIME 25 $C 1.5 µS THERMAL RESISTANCE R0JA SINGLE LAYER, SINGLE SIDED PCB 303 5 50 120 GAUSS RELEASE -120 -50 -5 GAUSS DIFFERENTIAL 50 100 170 GAUSS OPERATING TEMP -40 +150 $C STORAGE TEMP -40 +150 $C PARAMETER 10 5 0 -40 125 150 TEMPERATURE, DEG. C $C/W OPERATE ABSOLUTE MAXIMUM RATINGS D 20 VOLTAGE, V D C 2 CONDITIONS SUPPLY VOLTAGE MIN -28.0 APPLIED OUTPUT VOLTAGE -0.5 TYP MAX UNITS 28.0 VOLTS 28.0 VOLTS OUTPUT CURRENT 20.0 mA MAGNETIC FLUX NO LIMIT GAUSS B B BLOCK DIAGRAM CURRENT SINKING OUTPUT Vs (+) A HALL SENSOR TRIGGER CIRCUIT AND AMPLIFIER OUTPUT (O) A GROUND (-) C THIS DRAWING COVERS A PROPRIETARY ITEM AND IS THE PROPERTY OF HONEYWELL. THIS DRAWING IS NOT TO BE COPIED OR USED WITHOUT THE PERMISSION OF HONEYWELL. C SCALE 4 3 2 REV SIZE TYPE CAGE_CODE DRAWING NAME I - SS361RT NONE SHEET 1 E 3 OF 3