HERA1601G-HERA1608G 16.0AMP. Glass Passivated High Efficient Rectifiers TO-220AC .185(4.70) .175(4.44) Features .412(10.5) MAX .113(2.87) .103(2.62) Glass passivated chip junction. High efficiency, Low VF High current capability High reliability High surge current capability For use in low voltage, high frequency inventor, free wheeling, and polarity protection application. .27(6.86) .23(5.84) .594(15.1) .587(14.9) PIN1 2 .16(4.06) .14(3.56) .11(2.79) .10(2.54) .56(14.22) .53(13.46) .037(0.94) .027(0.68) Mechanical Data Cases: TO-220AC Molded plastic Epoxy: UL 94V-0 rate flame retardant Polarity: As marked High temperature soldering guaranteed: 260oC/10 seconds .16”,(4.06mm) from case. Weight: 2.24 grams .055(1.40) .045(1.14) DIA .154(3.91) .148(3.74) .025(0.64) .014(0.35) .205(5.20) .195(4.95) PIN 1 PIN 2 CASE Dimensions in inches and (millimeters) Maximum Ratings and Electrical Characteristics Rating at 25 oC ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20% Type Number Symbol Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average Forward Rectified Current @TC =100 oC Peak Forward Surge Current, 8.3 ms Single Half Sine-wave Superimposed on Rated Load (JEDEC method ) Maximum Instantaneous Forward Voltage @16.0A Maximum DC Reverse Current @TA=25 oC at Rated DC Blocking Voltage @ TA=125 oC VRRM VRMS VDC 100 200 300 400 600 800 1000 70 140 210 280 420 560 700 100 200 300 400 600 800 1000 A IFSM 250 A VF 1.0 1.3 IR Trr Cj 1.7 10 400 50 120 RθJC 80 80 2.0 -65 to +150 -65 to +150 TJ Storage Temperature Range TSTG 1. Reverse Recovery Test Conditions: IF=0.5A, IR=1.0A, IRR=0.25A Notes: 2. Measured at 1 MHz and Applied Reverse Voltage of 4.0V D. C. 3. Mounted on Heatsink Size of 2 in x 3 in x 0.25 in Al-Plate. http://www.luguang.cn V V V 16 Typical Junction Capacitance ( Note 2 ) Operating Temperature Range 50 35 50 Units I(AV) Maximum Reverse Recovery Time ( Note 1 ) Typical Thermal Resistance (Note 3) HERA HERA HERA HERA HERA HERA HERA HERA 1601G 1602G 1603G 1604G 1605G 1606G 1607G 1608G - 336 - mail:[email protected] V uA uA nS pF o C/W o C o C HERA1601G-HERA1608G 16.0AMP. Glass Passivated High Efficient Rectifiers FIG.1- MAXIMUM FORWARD CURRENT DERATING CURVE FIG.2- TYPICAL REVERSE CHARACTERISTICS 1000 20 16 INSTANTANEOUS REVERSE CURRENT. ( A) 12 8 4 0 0 50 100 150 o FIG.3- MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT 250 Tj=25 0C 200 150 10 Tj=25 0C 1 20 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE. (%) 100 FIG.5- TYPICAL FORWARD CHARACTERISTICS 100 Tj=25 0C HE 200 RA 16 01 150 G~ HE HE RA RA 16 16 06 100 G~ 05 G HE G 03 16 ~H 08 RA G RA 16 G 0.3 HE G~ 0.1 0.03 RA 50 1.0 05 06 250 16 16 300 3.0 A ER RA FIG.4- TYPICAL JUNCTION CAPACITANCE 30 10 ~H E 100 04 G 50 HE 20 1G 10 16 5 60 2 RA 1 RA 1 0 HE 50 NUMBER OF CYCLES AT 60Hz JUNCTION CAPACITANCE.(pF) Tj=125 0C 0.1 0 8.3ms Single Half Sine Wave JEDEC Method INSTANTANEOUS FORWARD CURRENT. (A) PEAK FORWARD SURGE CURRENT. (A) CASE TEMPERATURE. ( C) 100 HE AVERAGE FORWARD CURRENT. (A) RATINGS AND CHARACTERISTIC CURVES (HERA1601G THRU HERA1608G) 16 08 G 0.01 0.4 0 1 2 5 10 20 50 100 200 500 1000 0.6 0.8 1.0 1.2 1.4 1.6 FORWARD VOLTAGE. (V) REVERSE VOLTAGE. (V) FIG.6- REVERSE RECOVERY TIME CHARACTERISTIC AND TEST CIRCUIT DIAGRAM 50W NONINDUCTIVE 10W NONINDUCTIVE trr +0.5A (-) DUT (+) 50Vdc (approx) (-) PULSE GENERATOR (NOTE 2) 1W NON INDUCTIVE OSCILLOSCOPE (NOTE 1) NOTES: 1. Rise Time=7ns max. Input Impedance= 1 megohm 22pf 2. Rise Time=10ns max. Sourse Impedance= 50 ohms http://www.luguang.cn 0 -0.25A (+) -1.0A 1cm SET TIME BASE FOR 5/ 10ns/ cm mail:[email protected] 1.8