Preliminary Power Amplifier Pallet RTP08016-10 Product Features Application • Doherty amplifier design • Small and light weight • 50 Ohm Input/ Output impedance matched • Highly reliable and rugged design • High efficiency, High Gain • 16W typical PAVG •CDMA,W-CDMA Repeater Description The RTP08016-10 is designed for RF system application frequencies from 860MHz to 890MHz, with high gain. This Pallet Amplifier uses GaN on Sic HEMT technology which performs high breakdown voltage, high linearity, and high efficiency. The RTP08016-10 is a CDMA W-CDMA DPD application amplifier Electrical Specifications Specification @ 25℃ Parameter Operating Frequency Range 860-890 Technologies Supported CDMA, WCDMA Instantaneous Bandwidth 30MHz Operating Temperature -10℃ ~ +80℃ @ Plate Temperature Operating Voltage MHz Main voltage 45.0±1.0 Sub voltage 5.6±0.2 deg ℃ V Gain (25℃) 40±3.0 dB Gain Flatness < 1.5 dBp-p. Input/Output Return Loss > 18.0 dB Current Consumption Main current <1.0 max A Sub current < 0.1 max A Output Power 42 dBm Spectrum Mask (ACLR) Pre DPD < -25@ ∆5MHz dBc * Input Signal: Better than -58dBc Post DPD < -45@ ∆5MHz dBc Saturation Power > 49.5 dBm CCDF 7.5 dB Efficiency > 35.5 @ Plate Temperature % Coupling Value 0.7±1.0 dB Gain Flatness for feedback < 0.3 dBp-p. Note : Channel Bandwidth: 30 MHz(WCDMA 6FA), PAR ⇒ about 7.5 dB @ considering DPD ▪ Tel : 82-31-250-5078 ▪ All specifications may change without notice. ▪ [email protected] ▪ Version 1.0 Preliminary RTP08016-10 Power Amplifier Pallet Environmental Characteristics Parameter Symbol Min. Ta Tstg Operating Ambient Temperature Storage Temperature Relative humidity w/o condensation Typ. Max. Unit -10 +80 °C -40 +130 °C 95 % RH Mechanical Specifications Parameter SPECIFICATION RF Input Connector PAF-S05-013-004 RF Output Connector PAF-S05-013-004 RF Coupled Connector PAF-S05-013-004 DC Connector 53426-0910 Dimension (mm) 20(H) × 180(L) × 100(W) Cover Gasket (Inserting Type) 1.5(H) × 0.5(L) Maximum Rating POD +2dBm Max. Load VSWR Ψ ∞ : 1 (All Phase & Amplitude) Nom. Operating Case Temperature Tc +85 °C Input Overdrive Interface Connector Pin No. Name I/O Description 1 Enable(+5V) I PA Control Signal Voltage 2,4,6,9 GND - Ground 3 Temp O Temp Sensor Output Voltage 5 +5.6 Vdc I Amplifier’s Gate Voltage and MMIC drive voltage 7,8 +45 Vdc I Drive and Main Amplifier’s Drain Voltage *Note: Based on the customer’s need, RFHIC can provide different type of connector ▪ Tel : 82-31-250-5078 ▪ All specifications may change without notice. ▪ [email protected] ▪ Version 1.0 Preliminary Power Amplifier Pallet RTP08016-10 Outline Drawing *Note : Connector positions and module mount holes would be changed. Unit : mm RTP08016-10 Budget ▪ Tel : 82-31-250-5078 ▪ All specifications may change without notice. ▪ [email protected] ▪ Version 1.0 Preliminary Power Amplifier Pallet RTP08016-10 Test Data (WCDMA 6FA@16W/+45V, PAR=7.5dB) Test Equipment List z Spectrum Analyzer Agilent E4440A or Similar 1ea z Network Analyzer Agilent E5071 or Similar 1ea z Signal Generator E4438C or Similar 1ea z Power Supply : +60V/10A or Higher 1ea, +30V/5A or Higher 2Port 1ea z Power Meter N1912A or Similar 1ea (optional) z Power Sensor E9320A or Similar 1ea (optional) z Attenuator : 30dB, 250W or Similar 1ea z Coupler(30dB) or Similar 1ea z PC : VSA 89600A or Similar 1ea ▪ Tel : 82-31-250-5078 ▪ All specifications may change without notice. ▪ [email protected] ▪ Version 1.0 Preliminary Power Amplifier Pallet RTP08016-10 Test Result: DPD Operation (WCDMA 6FA) Non- DPD@875MHz_-10℃ WITH- DPD@875MHz_-10℃ Non- DPD@875MHz_+25℃ WITH- DPD@875MHz_-+25℃ Non- DPD@875MHz_+80℃ WITH- DPD@875MHz_+80℃ Note : -10℃ ~ +80℃ @ Plate Temperature ▪ Tel : 82-31-250-5078 ▪ All specifications may change without notice. ▪ [email protected] ▪ Version 1.0 Preliminary Power Amplifier Pallet RTP08016-10 Test Sheet (WCDMA 6FA@16W/+45V, PAR=7.5dB) Parameter Specification@ 25℃ Operating Frequency [MHz] 860~890 Output Power [dBm] +42.0 Pre DPD ACLR ∆5MHz [dBc] -26.9 Post DPD ACLR ∆5MHz [dBc] -50.4 Saturated Power [dBm] +49.87 Current 45.0V [A] +0.95 Current 5.6V [A] +0.07 Coupling Value [dBm] +0.86 Input Return Loss [dB] -32.7 Output Return Loss[dB] -21.3 Efficiency[%] +37.5 [Test Result] RFHIC Corporation (RFHIC) reserves the right to make changes to any products herein or to discontinue any product at any time without notice. RFHIC do not assume any liability for the suitability of its products for any particular purpose, and disclaims any and all liability, including without limitation consequential or incidental damages. The product specifications herein expressed have been carefully checked and are assumed to be reliable. However, RFHIC disclaims liability for inaccuracies and strongly recommends buyers to verify that the information they are using is current before placing purchase orders. RFHIC products are not intended for use in life support equipment or application where malfunction of the product can be expected to result in personal injury or death. Buyer uses or sells such products for any such unintended or unauthorized application, buyer shall indemnify, protect and hold RFHIC and its directors, officers, stockholders, employees, representatives and distributors harmless against any and all claims arising out of such use. RFHIC’s liability under or arising out of damages, claims of whatsoever kind and nature which RFHIC products could cause shall be limited in amount to the net purchase price of the products sold to buyer by RFHIC. ▪ Tel : 82-31-250-5078 ▪ All specifications may change without notice. ▪ [email protected] ▪ Version 1.0