HDMI® Port HDMI 1.4 - ESD & Overcurrent Protection Solution Products CG0402MLU-05G Objective Compliance HDMI 1.4 is a hot-pluggable interface combining video, audio & Ethernet signals. Voltages are 5 V or lower and the bandwidth is 340 MHz. This solution privides HDMI 1.4 ports with protection against ESD and short circuits without impairing the transmission of power or data IEC 61000-4-2 Level 4 (8 kV / 15 kV) Solution MF-FSMF020X-2 This solution provides IEC 61000 Level 4 ESD protection without impairing the HDMI signal. MF-FSMF020X-2 TMDS_D0+ TMDS_D0TMDS_DCLK+ TMDS_DCLKTMDS GND Design Kit CG0402MLU-05G HEC+ HEC- Half-duplex Ethernet CG0402MLU-05G The schematic above illustrates the application protection and does not constitute the complete circuit design. Customers should verify actual device performance in their specific applications. Americas: Tel +1-951 781-5500 Fax +1-951 781-5700 Europe: Tel +41-(0)41 768 55 55 Asia-Pacific: Tel +886-2 256 241 17 Fax +41-(0)41 768 55 10 HDMI ASIC CG0402MLU-05G HDMI Connector PN-DESIGNKIT-12 Other PortNote® Solutions: • HDMI: HDMI 1.3 - ESD & Overcurrent Protection Other ChipGuard® Protectors: CG0603MLU-05E, CG0402MLC-05LGA CG0603MLC-05LEA Benefit 9 ChipGuard® ESD Suppressors: CG0402MLU-05G 1 Multifuse® PTC Resettable Fuse: MF-FSMF020X-2 VCC +5V TMDS_D2+ TMDS_D2TMDS_D1+ TMDS_D1TMDS GND Alternate Recommendations Fax +886-2 256 241 16 COPYRIGHT© 2012 • BOURNS, INC. • 6/12 • e/CPK1137 • “PortNote” is a registered service mark of Bourns, Inc. “Bourns”, “Multifuse” and “ChipGuard” are registered trademarks of Bourns, Inc. in the U.S. and other countries. “HDMI” is a registered mark of its owner. Bourns® PortNote® solutions provide protection recommendations for typical port threats. For more information, go to: www.bourns.com or email: [email protected]