MwT-0618S-TCM/0618Z-TCM 6.0-18.0 GHz Balanced Temp. Comp. Module www.mwtinc.com Email: [email protected] TYPICAL SPECIFICATIONS AT 25 C FLAT FREQUENCY RESPONSE LOW INSERTION LOSS AT ZERO BIAS BUILT-IN THERMISTOR FOR TEMPERATURE COMPENSATION HIGH DYNAMIC RANGE 1.0 2.0 3.0 4.0 MIN ATT (@Zero Bias) Typical Input/Output Return Loss (dB) Typical Insertion Loss (dB) FLEXIBLE ADJUSTMENT TO SUIT DIFFERENT TEMPERATURE COMPENSATION REQUIREMENTS LOW VSWR MAX ATTENUATION 10.0 11.0 12.0 13.0 2 3 4 5 Frequency (GHz) FREQ IL ATTEN. IL/ F VSWR IN VSWR OUT VDC IDC 10 S11 15 20 25 S22 6 12 Frequency (GHz) 18 6 ELECTRICAL SPECIFICATIONS SYMBOL 5 (Ta=25 C) PARAMETERS Frequency Range Insertion Loss @ min Attentuation (No Bias) Insertion Loss @ max Attentuation Insertion Flatness over Freq @ any Atten. Input VSWR Output VSWR Power Supply Voltage DC Current UNITS MIN GHz dB dB +/-dB --------+V mA 6.0 12.0 6.0 TYP 2.5 13.0 0.6 1.6:1 1.6:1 8.0 10.0 4268 Solar Way Fremont California 94538 Phone: (510) 651-6700 Fax: (510) 651-2208 All rights reserved. MicroWave Technology, Inc. All specifications subject to change without notice. MAX 18.0 3.0 0.8 1.8:1 1.8:1 9.0 20.0 MwT-0618S-TCM/0618Z-TCM 6.0-18.0 GHz Balanced Temp. Comp. Module DC O .110 .246 .025 DC O .095 RF OUT .158 .088 O .062 .246 .158 .088 .062 O .184 Email: [email protected] .184 www.mwtinc.com .095 .110 .041 RF IN .08 .08 .08 .08 RF IN RF OUT .390 .405 .500 DC “S” .405 .500 “Z” Configurations Construction: Construction .390 .055 Max. w/Caps & Bond Wires DC 1. Dimension in Inches 2. Tolerance: XXX= +/- .005 XX= +/- .01 The 15 mil alumina substrates and 10 mil copper FET ridge are brazed onto the 25 mil carrier using AuGe preform. The PIN diodes are attached to the Cu ridge using AuSn preform. All capacitors are attached using AuSn preforms. The flanges are designed to accommodate 0-80 UNF-2A socket or Fillister head screws on .400 center-to-center hole spacing. The modules are mechanically and electrically designed to be cascaded. Notes: 1. Custom module specifications and/or custom module mechanical configurations are available. 2. Operating Temperature Range is -55 degrees Celsius to +105 degrees Celsius. 3. All modules are serialized and shipped with data measured at 25 degrees Celsius. Data includes swept small signal gain, swept input and output return loss. Noise figure and P-1dB are measured in 1 GHz increments. Special module testing is available. 4. Test Fixtures are available. 5. Microwave Technology reserves the right to ship modules with performance above the typical specifications. 4268 Solar Way Fremont California 94538 Phone: (510) 651-6700 Fax: (510) 651-2208 All rights reserved. MicroWave Technology, Inc. All specifications subject to change without notice.