ETC PR23EI-10/8786DIN/4-20MA

KELLER
PIEZORESISTIVE PRESSURE TRANSMITTERS
SERIES 23 / 25
ABSOLUTE-, GAUGE- AND DIFFERENTIAL PRESSURE
These piezoresistive transmitters have been designed for precision applications in industrial
environments for pressures ranging from 0,2 to 1000 bar, liquids or gas.
· Series 23
Male pressure port
Accuracy 0,5%FS, optional 0,1 and 0,2%FS
· Series 25
Flush diaphragm
Accuracy 0,5%FS, optional 0,1 and 0,2%FS
• A Complete Range
Absolute, barometric, gauge (over- and underpressure) and differential for wet/wet applications. 13 nominal pressure ranges. Current or voltage output.
• Flexibility
A modular concept uses the selection of off-the-shelf capsules, allowing a customised production. Numerous options and variants are available, fully adapted to the customer’s
requirements: Mechanical and electrical interface, ports, signal outputs, materials in media
contact, oil filling, oxygen-compatibility, special features, flameproof- and intrinsically safe
versions.
Series 23
• Reliability / Quality
These transmitters use the highly stable KELLER Series 10 capsules, proven in millions of
applications throughout the world. Each capsule is subjected to severe tests and calibration
procedures. The transmitters are manufactured and tested according to ISO 9001 / EN
29001.
The type of the transmitter is defined according to the reference pressure:
· PAA-23/25
· PA-23/25
· PR-23/25
· PD-23
Absolute Pressure Transmitter (Zero at 0 bar abs.)
Sealed Gauge Pressure Transmitter (Zero at ≈ 1 bar abs.)
Vented Gauge Pressure Transmitter (Zero at atmospheric)
Differential Pressure Transmitter (wet / wet)
SERIES PD 23
WITH DIN 43650 CONNECTOR
Series 25
SERIES 23
DIN 43650 CONNECTOR
SERIES 25
WITH CABLE
WITH
Cable
ø 7,3 mm
35 mm
ø22
ø22
75 mm
ø22
75 mm
72 mm
16
G 1/4"
Female
Port
G 1/4"
Female
Port
ø40
59,1
HEX 27
Viton
Flat Seal
10
16
Viton O-Ring Seal
or
Copper-Washer
HEX 27
12
14
G 1/2" or G 3/4"
G 1/4"
Subject to alterations
KELLER AG für Druckmesstechnik
KELLER Gesellschaft für druckmesstechnik mbH
Companies approved to ISO 9001 / EN 29001
St. Gallerstrasse 119
Schwarzwaldstrasse 17
CH-8404 Winterthur
D-79798 Jestetten
4/99
Tel. 052 - 235 25 25
Tel. 07745 - 9214 - 0
Fax 052 - 235 25 00
Fax 07745 - 9214 - 50
Internet: http://www.keller-druck.ch
KELLER
SPECIFICATIONS
PRESSURE RANGES (FS) IN BAR
-1
-0,5 -0,2
0,2 0,5
1
0,2 0,5
1
0,2 0,5
1
1
-1
-1
-1
2,5 2,5
3
1
1
2
200 bar max.
PR -23/25
PD-23
PAA-23/25
PA-23/25
Overpressure
Overpressure Ref.-Side PD
PD, static line pressure
2
2
2
2
4
3
5
5
5
5
10
7
10
10
10
10
20
15
Linearity(1)+Hysteresis+Repeatability
Storage-/Operating Temperature
Compensated Temperature Range
Temperature Coefficients…
· Range > 1 bar
· Range
1 bar
· Range 0,5 bar
· Range 0,2 bar
Stability
· Range > 2 bar
· Range ≤ 2 bar
±0,2%FS typ., ±0,5%FS max.
-40…100°C
-10…80°C
OF ZERO, IN %FS/°C
0,005 typ.
0,01 max.
0,010 typ.
0,02 max.
0,015 typ.
0,03 max.
0,025 typ.
0,05 max.
Signal Output / Type
Supply
Load Resistance (RΩ)
4...20 mA / 2-WIRE
10...30 VDC
(U-10V)/0,02A
Electrical Connection
Volumetric Change
Pressure Connection
Material in Media Contact
Protection
Weight
Insulation
Endurance
Frequency Response
- Plug DIN 43650, protection IP 65
- Cable (with reference tube for gauge); protection IP 65
< 0,1 mm3
See drawings front page
Stainless steel 316L (DIN 1.4435), viton
IP65
PR/PA/PAA: ≈ 180 g.
PD: ≈ 440 g
> 100 MΩ@50 V
> 10 million cycles 0…100%FS at 25°C
1 kHz (5 kHz option)
OPTIONS
Pressure Connection, Electrical Out
Pressure Ranges
Linearity. Specifications
Materials in Contact with Media
Oil Filling
Hazardous Applications
Protection
Higher Static Line Pressure
On request; many possibilities
All pressure ranges between 0,2 and 1000 bar, diff. units
±0,1 and ±0,2%FS or any customer requirement
Hastelloy C, monel, platinum, nickel, tantalum, gold-plated
Fluorized oil (O2-compatible), olive-oil, low temperature oil
Flameproof- and intrinsically safe version
IP67
up to 600 bar (PD only)
0,1%FS typ.
1 mbar typ.
200
300
400
600
600
900
1000
1100
SENSITIVITY, IN %/°C
0,02 max.
0,02 max.
0,02 max.
0,02 max.
OF
0,2%FS max.
2 mbar max.
0...20 mA / 3-WIRE
10...28 VDC
(U-5V)/0,02A
0...10 V / 3-WIRE
13...28 VDC
>5k
Series PD-23
T R A N S M I T T E R
white
red
+Supply
+Supply
3
3
black
red
2
black
1
2
red
1
Signal
white
0 V / GND
+Signal
2-Wire
4…20 mA
3-Wire
0…20 mA
black
3-Wire
Cable
red
Amphenol
C91A
white
DIN 43650
Connector
black
-
Three Wire
Transmitter
50
100
100 200
(1) best straight line, based zero
ELECTRICAL CONNECTIONS
Two Wire
Transmitter
20
20
20
20
40
25
+
Load
Load
-
+
GND
13…28 V
+
GND
10…28 V
+
S
I
G
N
A
L
GND
10…30 V
S U P P L Y
Subject to alterations
KELLER AG für Druckmesstechnik
KELLER Gesellschaft für druckmesstechnik mbH
Companies approved to ISO 9001 / EN 29001
St. Gallerstrasse 119
Schwarzwaldstrasse 17
CH-8404 Winterthur
D-79798 Jestetten
4/99
Tel. 052 - 235 25 25
Tel. 07745 - 9214 - 0
Fax 052 - 235 25 00
Fax 07745 - 9214 - 50
Internet: http://www.keller-druck.ch