8 Pin DIP Dual TTL Compatible Active Delay Lines DELAY TIME* PART NUMBER DELAY TIME* PART NUMBER DELAY TIME* PART NUMBER 5±1 6±1 7±1 8±1 9±1 10 ± 1.5 11 ± 1.5 12 ± 1.5 13 ± 1.5 14 ± 1.5 15 16 17 EPA445-5 EPA445-6 EPA445-7 EPA445-8 EPA445-9 EPA445-10 EPA445-11 EPA445-12 EPA445-13 EPA445-14 EPA445-15 EPA445-16 EPA445-17 18 19 20 21 22 23 24 25 30 35 40 45 50 EPA445-18 EPA445-19 EPA445-20 EPA445-21 EPA445-22 EPA445-23 EPA445-24 EPA445-25 EPA445-30 EPA445-35 EPA445-40 EPA445-45 EPA445-50 55 60 65 70 75 80 85 90 95 100 150 200 250 EPA445-55 EPA445-60 EPA445-65 EPA445-70 EPA445-75 EPA445-80 EPA445-85 EPA445-90 EPA445-95 EPA445-100 EPA445-150 EPA445-200 EPA445-250 Delay Times referenced from input to leading edges at 25°C, 5.0V, with no load. * Unless otherwise specified, delay tolerance is ± 2 nS or ± 5%, whichwver is greater. DC Electrical Characteristics Parameter Test Conditions VOH VOL VIK IIH Schematic Min Max Unit High-Level Output Voltage Low-Level Output Voltage Input Clamp Voltage High-Level Input Current V CC = min. VIL = max. I OH = max 2.7 V CC = min. VIH = min. I OL= max V CC = min. II = II K V CC = max. VIN = 2.7V V CC = max. VIN = 5.25V IIL Low-Level Input Current V CC = max. VIN = 0.5V IOS Short Circuit Output Current V CC = max. VOUT = 0. -40 (One output at a time) ICCH High-Level Supply Current V CC = max. VIN = OPEN ICCL Low-Level Supply Current V CC = max. VIN = 0 TRO Output Rise Time NH Fanout High-Level Output V CC = max. VOH = 2.7V NL Fanout Low-Level Output V CC = max. VOL = 0.5V Recommended Operating Conditions VCC VIH VIL IIK IOH IOL PW* d* TA Supply Voltage High-Level Input Voltage Low-Level Input Voltage Input Clamp Current High-Level Output Current Low-Level Output Current Pulse Width of Total Delay Duty Cycle Operating Free-Air Temperature 0.5 -1.2V 50 1.0 -2 -100 V V V µA mA mA mA Max Unit 4.75 2.0 5.25 V V V mA mA mA % % °C 0.8 -18 -1.0 20 40 0 40 +70 5 1 4 GROUND PCA EPA455-5 Date Code WHITE DOT PIN#1 Unit 3.2 110 2.0 1.0 5.0 .280 Max. All unused pins are omitted. .500 Max. .020 Typ. .250 Max. Input Pulse Test Conditions @ 25° C .010 Typ. .120 Min. . .100 Typ. .365 Max. Volts % nS MHz Volts QAF-CSO1 Rev. B 8/25/94 DSA445 8/25/94 Unless Otherwise Noted Dimensions in Inches Tolerances: Fractional = ± 1/32 8 .XX = ± .030 .XXX = ± .010 7 1 90 mA 90 mA 4 nS 20 TTL LOAD 10 TTL LOAD .020 Typ. Pulse Input Voltage Pulse Width % of Total Delay Pulse Rise Time (0.75 - 2.4 Volts) Pulse Repetition Rate Supply Voltage VCC Package Dimensions Min *These two values are inter-dependent. EIN PW TRI PRR VCC 8 ELECTRONICS INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 TEL: (818) 892-0761 FAX: (818) 894-5791