SURFACE MOUNT LEDs - 3x2 Blue 1.5 max 2.0 1.7 1 1.6 1, Anode 3.0 1.2 1 • • High Intensity • • • Solid state reliability Also available as a 3mm device Wide viewing angle Ideal for backlighting 120053 SERIES 2 2, Cathode 2 0.5 MLQ = 50 Chip Dimensions in mm (Typical) Tolerance +/- 0.2 UOS Not to Scale Cathode mark Ordering Information & Typical Technical Characteristics (Ta = 25°C) Mean Time Between Failure = 100,000 Hours. * Duty Cycle <=1/10, Pulse Width <= 10msec PART NUMBER COLOUR TYP. FWD VOLTAGE Vf @ Iopr MAX FWD VOLTAGE Vf @ Iopr FORWARD CURRENT lopr MAX REV CURRENT I r(Vr =5V) LUMINOUS INTENSITY lv@lopr CHROMATICITY COORDINATES VIEWING ANGLE 2θ 1/2 STANDARD INTENSITY OPTICAL / ELECTRICAL CHARACTERISTICS (Ta = 25 oC) - 120053 Blue 3.6 4.0 20 50 90 120 UNITS Water Clear V V mA µA mcd x/y deg PART NUMBER COLOUR FORWARD CURRENT Iopr max PEAK FWD CURRENT I fp * REVERSE VOLTAGE Vr max POWER DISSIPATION P dmax DOM WAVELENGTH Typ. λD OPERATING TEMP T opr STORAGE TEMP T stg STANDARD INTENSITY ABSOLUTE MAXIMUM- RATINGS (Ta = 25oC) 120053 Blue 25 80 5 100 470 -20 to +80 -30 to +100 UNITS Water Clear mA mA Vdc mW nm °C °C PRECAUTIONS FOR HANDLING ELECTROSTATIC SENSITIVE LEDs Static Electricity and Surge Static electricity and surge will damage the LED and a high standard of care must be taken during handling. It is recommended that a wristband, conductive mat or anti-electrostatic glove is used when handling the LEDs. All devices, equipment (e.g. soldering iron points) and machinery must be properly grounded. SAFETY PRECAUTIONS FOR HANDLING HIGH BRIGHTNESS LEDs The light output of the Products may cause injuries to human eyes in circumstances where they are viewed directly with unshielded eyes for more than a few seconds. Please refer to European Standard BSEN 100015-1 1992 for further information. © Marl Optosource 2000 Datasheet Reference 25/98 Issue 02 Marl Optosource • Fax: +44 (0)1229 580012 • email: [email protected] • website: www.optosource.com • Telephone +44 (0)1229 582430