MARL 100044

0.5+/-0.5
•
•
1.5 max
•
•
ø3.1
Anode
1.0
ø3.8
2.5
0.75 max
DISCRETE LEDs - Ø 3mm BLUE
5.0
3.5
High intensity
Also available as a
5mm device
Solid state reliability
Can be supplied in
bulb replacement and
panel mounting
formats
6.0
100044 SERIES
11.0+/-0.5
27.5+/-1
2.0
Dimensions in mm (Typical)
Tolerance +/- 0.2 UOS
Not to Scale
Ordering Information & Typical Technical Characteristics (Ta = 25°C)
* Duty Cycle <= 1/10, Pulse Width <= 10msec
PART
NUMBER
COLOUR
TYP. FWD
VOLTAGE
Vf@lopr
MAX FWD
VOLTAGE
Vf@lopr
FORWARD
CURRENT
lopr
MAX REV
CURRENT
lr(Vr=5V)
TYPICAL LUMINOUS
INTENSITY
lv@lopr
TYPICAL CHROMATICITY
COORDINATES
@lopr
VIEWING
ANGLE
2ø½
OPTICAL/ELECTRICAL
CHARACTERISTICS
(Ta = 25°C)
STANDARD
INTENSITY
100044
Blue
3.6
4.0
20
50
2300
0.13 / 0.075
15
UNITS
Water Clear
V
V
mA
uA
mcd
x/y
deg
PART
NUMBER
COLOUR
FORWARD
CURRENT
lopr max
REVERSE
VOLTAGE
Vr max
POWER
DISSIPATION
P dmax
DOM
WAVELENGTH
Typ. λd
OPERATING
TEMP
Topr
STORAGE
TEMP
Tstg
PEAK FWD
CURRENT
lfp *
ABSOLUTE MAXIMUM
RATINGS (Ta = 25°C)
STANDARD INTENSITY
100044
Blue
30
100
5
120
470
-30 to +85
-40 to +100
UNITS
Water Clear
mA
mA
Vdc
mW
nm
°C
°C
PRECAUTIONS FOR HANDLING ELECTROSTATIC SENSITIVE LEDs
Static Electricity and Surge
Static electricity and surge will damage the LED and a high standard of care must be taken during handling. It is recommended
that a wristband, conductive mat or anti-electrostatic glove is used when handling the LEDs. All devices, equipment (e.g.
soldering iron points) and machinery must be properly grounded.
SAFETY PRECAUTIONS FOR HANDLING HIGH BRIGHTNESS LEDs
The light output of the Products may cause injuries to human eyes in circumstances where they are viewed directly with
unshielded eyes for more than a few seconds.
Please refer to European Standard BSEN 100015-1 1992 for further information.
© MARL OPTOSOURCE 2006 : DS 100044 Issue 1
Telephone +44 (0)1229 582430 •
Fax: +44 (0)1229 580012
•
email: [email protected]
•
website: www.optosource.com
The information contained in this datasheet does not constitute part of any order or contract and should not be regarded as a representation relating to
either products or service. Marl International reserve the right to alter without notice the specification or any conditions of supply for products or service.